Abstract:Empty Fruit Bunches (EFB) are oil palm waste that has the potential as a source of bioenergy because it contains lignocellulose (cellulose, hemicellulose, and lignin) so that it can be converted into biofuel through thermal cracking, adsorption, and distillation processes. Thermal cracking is the decomposition of the chemical content of biomass by utilizing heat without a mixture of oxygen at a temperature of 200oC–600oC. This study aims to obtain the characteristics of the raw material of EFB in the form of proximate, ultimate, lignin, and biofuel produced. The research was conducted using a thermal cracking reactor designed to control the temperature at 300oC, 350oC, 400oC, and 450oC. The results showed that the raw material characteristics of EFB from proximate were 13.66% water content, 8.74% ash content, 58.66% volatile matter and 18.90% fixed carbon. This water content is relatively high. This is because the drying process on the material has not run perfectly. The ultimate result showed that the EFB had a C content of 54.45%, H content of 5.00%, and O content of 16.27%. The atomic ratio obtained from the ultimate analysis can indicate the amount of calorific value that can be used for certain fuels. The smaller the atomic ratio value contained, the more significant the calorific value contained in a particular fuel. Klason method was carried out to decrease the level of lignin through 4 stages; the lignin content without delignification was resulting into 24.87%, the addition of aquadest was resulting into18.71%, the addition of 5% HCl resulting into 15.34%, and 10% HCl resulting into 14.49%. Delignification of 10% HCl is the pretreatment process before the thermal cracking. The thermal cracking process forms steam; the steam is then condensed to obtain bio-oil. The formed bio-oil was kept to separate the oil from tar. In order to obtain good biofuel quality, adsorption is carried out with zeolite adsorbent, which has been activated with HCL. A comparison of the physical properties of bio-oil before and after adsorption shows a color difference from brownish black to the adsorbed bio-oil, which is distilled to separate the heavy and light fractions. The temperature of 450oC at thermal cracking is close to optimum; when the temperature is increased, the cracking process will be more straightforward and occur optimally. The biofuel produced in this study was tested for its characteristics such as, density (927-1086.68 Kg/m3), kinematic viscosity (1.17-1.43 mm2/s), and flash point (66.00-70, 23oC). The biofuel product produced is dominated by C5-C15 compounds (45.07%) according to the results of GC-MS analysis.

Characterization of FTIR in Graphite from Palm Oil Waste with Ferric Chloride Catalyst

Analysis and Characterization of Graphene Oxide Derived from Oil Palm Empty Fruit Bunch Using X-Ray Diffraction

Low temperature synthetic graphite from oil palm trunk waste via pyrolisis process

Characteristics and modeling kinetics of oil palm frond petiole pyrolysis using thermogravimetric analyzer

Physicochemical characterisation and kinetic modelling of wet torrefied oil palm trunk in pyrolysis condition

Characteristics of Carbon from Oil Palm Shell Activated by Low Concentration of Zinc Chloride Activator

The synthesis of biographene oxide from the graphitic structure of PKS, EFB and OPF

Synthesis and Characterization of Activated Carbon from Lignocellulosic Biomass: Oil Palm Empty Fruit Bunches and Mahogany Sawdust

Characterization of bio-oil and biochar from slow pyrolysis of oil palm plantation and palm oil mill wastes

Pyrolysis of oil palm trunk biomass using a fixed bed reactor to produce raw material for bio-carbon black

Characterization Biofuel from Empty Fruit Bunch through Thermal Cracking

Acetylation of oil palm empty fruit bunch fiber as an adsorbent for removal of crude oil

The characterization of pyrolysis oil from plastic waste using FTIR and GC-MS techniques

Catalytic microwave pyrolysis of oil palm fiber (OPF) for the biochar production

Effect of carbonisation temperature and activating agents on the characteristics of activated carbon produced from oil palm empty fruit bunch

Product distributions and olefin-to-paraffin ratio over an iron-based catalyst for Fischer–Tropsch synthesis

FTIR, SEM and XRD analysis of activated carbon from sago wastes using acid modification

Characterization of Biochar Empty Fruit Bunches OPEFB at Various Temperatures and Burning Time

Preparation of Graphene-Supported Fe3O4 Model Catalysts for Fischer-Tropsch Synthesis

Selective depolymerization of sugarcane bagasse anaerobic digestate to highly stable phenols-rich bio-oil with the iron-doped K-feldspar catalyst

Effect of blending ratio to the liquid product on co-pyrolysis of low rank coal and oil palm empty fruit bunch