A sustainable approach for the synthesis of bismuth molybdate by continuous flow method using custom design reactor and their photocatalytic application for environmental remediation

Brijesh Kumar Shukla,Shalu Rawat,Hema Bhandari,Jiwan Singh,Seema Garg

DOI: https://doi.org/10.1007/s13204-022-02524-4

2022-06-28

Applied Nanoscience

Abstract:Continuous flow synthesis, an old industrial technique has gained tremendous interest in chemical laboratories and is now being shown in miniaturized devices in the research laboratories. Synthesis and production scale-up of nanoparticles are major challenges in nanotechnology and the use of continuous flow procedures may be the alternative solution to overcome this problem and need through the continuous scale-up of nanoparticles. Herein a protocol to synthesize amorphous and pure Bi2MoO6 phase by varying operating pH of reaction mass using a custom design mesofluidic device, continuous flow method has been established. The present study shows a significant effect of process pH on the nature of the synthesized bismuth molybdate. The feature and morphology of synthesized nanoparticles were explored by several analytical methods including powder X-ray diffraction (P-XRD), scanning electron microscope (SEM), and energy-dispersive X-ray spectroscopy (EDS). P-XRD analysis showed the synthesis of amorphous materials at acidic pH (pH 1 and 3), whereas crystalline materials with different morphologies were obtained at neutral and basic pH. However, the amorphous material was successfully converted into the crystalline phase by its calcination at 600 °C. Material synthesized at basic pH with crystalline nature showed better catalytic activity. Further, the photocatalytic activity of synthesized materials was evaluated for the degradation of methyl orange dye (MO) under the irradiation of visible light and it was found that phase pure crystalline Bi2MoO6 synthesized at pH 9 degraded ~ 65% of MO in 120 min with optimized process conditions by full factorial statistical method at optimum process parameters such as 10 mg/L concentration of MO, 1.0 g/L dosage of catalyst at pH 7.

nanoscience & nanotechnology