Abstract:In the current study, we have isolated various types of microplastics from the surface water of Rohtak, Haryana, India. The microplastics were isolated using stereo microscope, which was further characterized using scanning electron microscopy. Microplastic (MP) contamination has become a serious environmental concern that affects terrestrial environments, aquatic ecosystems, and human health. The current study assesses the presence, abundance, and morphology of MPs present in the surface water of Rohtak district, Haryana, India, which is rapidly undergoing industrialization. While the morphological studies of MPs were conducted through stereo microscopy and field emission‐scanning electron microscopy (FE‐SEM), the elemental composition of polymers was analyzed through attenuated total reflectance‐Fourier transform infrared (ATR‐FTIR). The results revealed that the surface water was significantly contaminated by polyethylene, polypropylene, and polystyrene. Moreover, the abundance of MPs was found to be 16–28 particles/L with an average value of 23 particles/L. Most of the MPs had fibrous morphology with the specifics being, fibers (43.9%), fragments (23.7%), films (17%), and pellets (15.4%). The MPs exhibited a size range of 0.61–4.87 mm, with an average size measured at 2.03 ± 0.04 mm. Also, the MP pollution load index values for the surface water bodies were found to be below 10, indicating a low risk category. Though currently designated as "low risk," it is important that mitigation strategies be brought over at this juncture to further prevent the deterioration of quality of water. Thus, this study not only intends to bring forth the impact of human activities, industrial waste, open waste dumping, and inadequate municipal waste management practices on increasing MP concentration but also highlights the sustainable alternatives and strategies to address this emerging pollutant in urban water systems. For further prevention, the implementation of stringent regulations and on‐site plastic waste segregation is a critical component in preventing the disposal of plastic waste in surface water bodies. Research Highlights The abundance of MPs was found to be 16–28 particles/L, with an average value of 23 particles/L. The surface water bodies in Rohtak district fall into the hazard categories of low risk with values less than 10. The overall MP concentration in water, across all five areas, based on color was in order: white/transparent (39.1%), black (15%), gray (9.1%), green (8.7%), blue (7.8%), red (7.8%), orange (6.3%), and yellow (6.1%). The dominant polymers were polyethylene (PE) (42%) and polypropylene (41%) as determined by FTIR spectroscopy.

Qualitative characterisation and identification of microplastics in a freshwater dam at Gauteng Province, South Africa, using pyrolysis–gas chromatography–time of flight–mass spectrometry (Py–GC–ToF–MS)

Detection and characterisation of microplastics in tap water from Gauteng, South Africa

Environmental concentrations, characteristics and risk assessment of microplastics in water and sediment along the Western Cape coastline, South Africa

Microplastic Abundance and Sources in Surface Water Samples of the Vaal River, South Africa

Assessment, characterization, and quantification of microplastics from river sediments

Temporal and spatial distribution of microplastics in green infrastructures: Rain gardens

Identification of Microplastic Pathways within a typical European Urban Wastewater System

Morphological and Chemical Characteristics of Microplastics in Surface Water of the Vaal River, South Africa

Optimization, performance, and application of a pyrolysis-GC/MS method for the identification of microplastics

Quantification of Microplastics by Pyrolysis Coupled with Gas Chromatography and Mass Spectrometry in Sediments: Challenges and Implications

Characteristics, fate, and sources of microplastics contaminant in surface water and sediments of River water

Quantitative analysis of microplastics in Nile tilapia from a recirculating aquaculture system using pyrolysis–gas chromatography–mass spectrometry

Application of GCMS-pyrolysis to estimate the levels of microplastics in a drinking water supply system

The abundance and analytical characterization of microplastics in the surface water of Haryana, India

Microplastic particles in river sediments and water of southwestern Nigeria: insights on the occurrence, seasonal distribution, composition, and source apportionment

Time-varying microplastic contributions of a large urban and industrial area to river sediments

Rapid Monitoring Approach for Microplastics Using Portable Pyrolysis-Mass Spectrometry

Invisible Peril: Assessing microplastic pollution in Ghanaian mangroves

Microplastic accumulation dynamics in Han river headwaters: Sediment interactions and environmental implication

Routine method for the analysis of microplastics in natural and drinking water by pyrolysis coupled to gas chromatography-mass spectrometry

Assessment of Microplastics from Surface Water Bodies: Challenges and Future Scopes