Changes in the design and operation of the accumulatory part of domain furnaces in the process improving fuel technology

Kuznetsov M,Kryachko G,Sigarev E

DOI: https://doi.org/10.34185/tpm.1.2022.01

2022-01-05

Theory and practice of metallurgy

Abstract:The purpose is the detection of changes in the design and operation of the storage part of blast furnaces, due to i mprovements in smelting technology, as well as increasing power and specific productivity of units. The methodology based on the use of a new approach to assessing the technological capabilities of the furnace and storage part of blast furnaces in the study of design and practical information on the profiling of furnaces over a period of time characterized by dynamic development of units and cast iron smelting technology. Findings The proposed characteristics of the technological capabilities of the furnace and the storage part of the furnace, as well as criteria for assessing these characteristics - the share of the storage part per air lance V_nch / n_f, the power of one air lance and the relative to the countercurrent part of the furnace / V_pr. It is shown that in the design and operation of blast furnaces it is desirable to maintain the criteria V_nch / n_f and V_nch / n_chl at the lowest possible level, and the criteria of air lance power and V_zum / V_pr at the maximum. There is a tendency to slow down the height of the furnace with increasing the useful volume of the furnaces. In modern furnaces, for every additional 1000 m3 of usable volume, the height of the furnace increased by an average of 9%. It is shown that the outstripping increase in the depth of the sump in comparison with other dimensions of the profile is due not only to its structural function, but also purely technological, namely the sump cast iron heat, which increases the inertia of the blast furnace process, and also participates in the cycle of accumulation and release of smelting products. Since the sump is part of the working space of the furnace, it is proposed to change the approach to determining the complete and useful height of the blast furnace. More specifically, the full height should be considered the distance from the ladder to the upper edge of the support ring (flange) of the grate cover, and useful - to the cone or tray of the backfill device in the lower working position. The study’s originality is to justify the new principles of the approach to assessing the technological capabilities of the furnace and storage part of blast furnaces, as well as to justify the need to consider the sump or dead layer as the sixth element of the profile. The practical value is to develop recommendations on the direction of changes in the design of the furnace and storage part of blast furnaces in the design of new and modernization of existing units, as well as a new approach to determining the useful and complete height of the furnace profile.