Fabrication of Organic Solvent Nanofiltration Membrane through Interfacial Polymerization Using N-Phenylthioure as Monomer for Dimethyl Sulfoxide Recovery

Ayang Zhou,Guangle Hu,Keying Guo,Mengnan Zhang,Xiangnan Liu

DOI: https://doi.org/10.3390/separations10030179

2023-03-07

Separations

Abstract:To recover dimethyl sulfoxide, an organic solvent nanofiltration membrane is prepared via the interfacial polymerization method. N-Phenylthiourea (NP)is applied as a water-soluble monomer, reacted with trimesoyl chloride (TMC) on the polyetherimide substrate crosslinked by ethylenediamine. The results of attenuated total reflectance-fourier transform infrared spectroscopy and X-ray electron spectroscopy confirm that N-Phenylthiourea reacts with TMC. The membrane morphology is investigated through atomic force microscopy and scanning electronic microscopy, respectively. The resultant optimized TFC membranes NF-1NP exhibited stable permeance of about 4.3 L m−2 h−1 bar-1 and rejection of 97% for crystal violet (407.98 g mol−1) during a 36 h continuous separation operation. It was also found that the NF-1NP membrane has the highest rejection rate in dimethyl sulfoxide (DMSO), and the rejection rates in methanol, acetone, tetrahydrofuran, ethyl acetate and dimethylacetamide(DMAc) are 51%, 84%, 94%, 96% and 92% respectively. The maximum flux in the methanol system is 11 L m−2 h−1 bar−1, while that in acetone, tetrahydrofuran, ethyl acetate and DMAc is 4.3 L m−2 h−1 bar−1, 6.3 L m−2 h−1 bar−1, 3.2 L m−2 h−1 bar−1, 4.9 L m−2 h−1 bar−1 and 2.1 L m−2 h−1 bar−1, respectively. It was also found that the membrane prepared by N-Phenylthiourea containing aromatic groups has lower mobility and stronger solvent resistance than that of by thiosemicarbazide.

chemistry, analytical