Abstract:Phenolic compound even at low concentrations, are considered to be priority pollutants due to their significant toxicity. Electrospinning was used to create a polyacrylonitril (PAN) nanofiber, which was then impregnated with graphene oxide (GO). After a preliminary investigation into the electrospinning parameters (e.g., using various voltages and polymer concentrations), the electrospun nanofibres were tuned, this study evaluated the effectiveness of these materials in removing phenolic compounds from wastewater through adsorption. Scanning electron microscopy (SEM) and Fourier transform infrared spectroscopy (FTIR) were used to analyze the synthesized nanofiber mats. The scanning electron microscopy (SEM) analysis revealed that the structure of nanofiber mats was altered by the addition of graphene oxide (GO) in different ratios. Specifically, the surface of the fibres exhibited increased roughness, and the diameter of the fibres also experienced an increase. The average diameter of the fibres was measured to be (134.9 ± 21.43 nm) for the PAN/2.5% GO composite and (198 ± 33.94 nm) for the PAN/5% GO composite. FTIR spectra of the PAN/GO nanocomposites nanofiber displayed distinct peaks associated with graphene oxide (GO). These included a wide peak at 3400 cm-1, related to the presence of hydroxyl (O-H) groups, as well as peaks on 1600 as well as 1000 cm-1, which indicated the existence of epoxy groups. In this study response surface methodology (RSM) was implemented. To enhance the efficiency of removing substances, it is necessary to optimise parameters such as pH, contact time, and dosage of the adsorbent. The optimum pH for removing phenol via all nanofiber mats was determined to be 7, while at a dose of 2 mg dose adsorbents maximum removals for pure PAN, PAN/2.5 GO, and PAN/5 GO were 61.3941, 77.2118, and 92.76139%, respectively. All the adsorbents obey Langmuir isotherm model, and the empirical adsorption findings were fitted with the second-order model kinetically, also non-linear Elovich model. The maximal monolayer adsorption capacities for PAN, PAN/2.5 GO, and PAN/5 GO were found to be 57.4, 66.18, and 69.7 mg/g, respectively. Thermodynamic studies discovered that the adsorption of phenol on all adsorbents nanofiber mats was exothermic, the adsorption of phenol on nanofiber mats decreases as the temperature increases. All the adsorbents exhibit negative enthalpy and entropy. The PAN/GO composite's superior phenol removal suggested that it could be used as a latent adsorbent for efficient phenol removal from water and wastewater streams.

Synthesis of novel epichlorohydrin cross-linked β-cyclodextrin functionalized with reduced graphene oxide composite adsorbent for treatment of phenolic wastewater

Removal of phenol from aqueous solution using reduced graphene oxide as adsorbent: isotherm, kinetic, and thermodynamic studies

Cellulose-based thermosensitive supramolecular hydrogel for phenol removal from polluted water

Evaluation of reduced graphene oxide from cotton waste as an efficient phenol adsorbent in aqueous media

Enhanced adsorption of phenolic compounds using biomass-derived high surface area activated carbon: Isotherms, kinetics and thermodynamics

Thermodynamic and kinetic analysis of the response surface method for phenol removal from aqueous solution using graphene oxide-polyacrylonitrile nanofiber mats

Behaviour and mechanics of phenolic sorption by novel bio-based graphene derivatives as adsorbents

Adsorption of paraquat from water by insoluble cyclodextrin polymer crosslinked with 1,2,3,4-butanetetracarboxylic acid

Adsorptive removal of phenol from synthetic wastewater using hexadecyltrimethylammonium bromide-functionalized cellulose nanocrystal (HDTMA-Br/CNCs)

Water-insoluble Β-Cyclodextrin Polymer Crosslinked by Citric Acid: Synthesis and Adsorption Properties Toward Phenol and Methylene Blue

Efficient and rapid removal of typical phenolic compounds from water with biobased porous organic polymers

Catechol-Based Porous Organic Polymers for Effective Removal of Phenolic Pollutants from Water

Porous multifunctional phenylcarbamoylated-β-cyclodextrin polymers for rapid removal of aromatic organic pollutants

Sorption of 4-n-nonylphenol, 4-n-octylphenol, and 4-tert-octyphenol on cyclodextrin polymers

Bio-Graphene Foam: A Robust Solution for Adsorptive and Sustainable Chlorophenol Removal from Wastewater

Adsorption of chlorpyrifos in water using polyaniline/graphene oxide composites

Cyclodextrin–epichlorohydrin polymers synthesis, characterization and applications to wastewater treatment: a review

Construction of aldehyde-based, ester-based hyper-cross-linked polar resin and its selective adsorption mechanism for phenol in coal chemical wastewater

β-Cyclodextrin-epichlorohydrin polymer/graphene oxide nanocomposite: preparation and characterization

A new eco-friendly method for efficient recovery and reuse of phenols in a semi-coke wastewater

Synthesis of aluminum alginate/graphene oxide/boehmite biopolymeric nanohybrid for the decontamination of Cu(II) and 2-chlorophenol