Abstract:Extended abstract One of the most important in situ experiments for determining rock mass fracture is a direct shear test. During this test, rock mass is loaded in two phases: in the first phase, a direct normal pressure is applied and consolidation is performed, and in the second phase, a shearing stress is applied, which leads to fracture in rock mass. After fracture is reached (peak shear strength), stress decreases and shear deformation increases [1]. In this paper a simulation of rock mass behavior during direct shear test using damage plasticity model [2,3,4] is presented. For this analysis, a three-dimensional FEM model of direct shear test with dimensions 130x80x60 m was formed. In the first phase of the FEM test normal stress corresponding to measured pressure during in situ test was applied, and in the second phase of the FEM test shear displacement corresponding to recorded displacement during in situ test was applied. In the first phase normal displacements are recorded based on calculations from the FEM model, and in the second phase shear stresses are recorded. The damage plasticity model [2,3,4] is defined by the following parameters: E 0 -Modulus of elasticity, v 0 - Poisson’s ratio, f c - uniaxial compressive strength, f t - uniaxial tensile strength, a c - pressure curve parameter, D c - degradation value for maximum compressive stress, a t - tensile curve parameter, D t - degradation value for tensile stress, G c - fracture energy for uniaxial pressure, G t - fracture energy for uniaxial tension, α p - dilatancy parameter, α - constant defining uniaxial and biaxial compressive yield stress ratio, γ - parameter for triaxial compression, l ch - characteristic size of elements, s 0 - stiffness recovery parameter, D cr - critical degradation value. Numerical simulation of direct shear test (consolidation phase and shear phase) was performed for the estimated parameters of damage plasticity model. For each step of normal stress loading, corresponding value of normal displacement was calculated, and for each step of shear displacement, corresponding value of shear stress was calculated. Based on the obtained results, it is shown that damage plasticity model can successfully simulate a complex stress state during direct shear test in rock mass. Over the entire range of applied shear displacements, shear stress increases until there is a fracture in the material (peak shear strength), and afterwards stress drop is recorded (residual shear strength).

A Novel Staged Cyclic Damage Constitutive Model for Brittle Rock Based on Linear Energy Dissipation Law: Modelling and Validation

Modelling rock mass behaviour during direct shear stress test using damage plasticity model

Statistical damage constitutive model based on energy conversion for rocks

A Time-Dependent Damage Constitutive Model for Brittle Rock Materials Based on Subcritical Damage Theory

A New Rock Damage Constitutive Model Based on Usher Function and its Application to Brittleness Evaluation

Validation of a damage constitutive model based on logistic model dedicated to the mechanical behavior of the rock

Energy Evolution of Rock under Different Stress Paths and Establishment of A Statistical Damage Model

Plastic damage fracture characteristics and constitutive modeling of rocks under uniaxial compression considering crack geometry

Constitutive Model of Rock Uniaxial Damage Based on Rock Strength Statistics

The fractal damage constitutive model of rock materials

Damage constitutive model of jointed rock mass considering structural features and load effect

A novel meso-damage constitutive model of rock under true triaxial stress with three-dimensional cracking strength, threshold and closure effect

A constitutive model for rock based on energy dissipation and transformation principles

A novel anisotropic deterioration mechanical model for rock ductile–brittle failure under 3D high-stress and its application

A dynamic damage constitutive model and three-dimensional internal crack propagation of rock-like materials in bond-based peridynamic

Experimental and constitutive model study on the mechanical properties of a structural plane of a rock mass under dynamic disturbance

An Elasto-Plastic Damage Model for Rocks Based on a New Nonlinear Strength Criterion

Stress–Energy Mechanism for Rock Failure Evolution Based on Damage Mechanics in Hard Rock

A Damage Constitutive Model for a Jointed Rock Mass under Triaxial Compression

A statistical damage-based constitutive model for shearing of rock joints in brittle drop mode

A rock damage constitutive model and damage energy dissipation rate analysis for characterising the crack closure effect