Backstepping Control Based on Adaptive Neural Network and Disturbance Observer for Reconfigurable Variable Stiffness Actuator
Yanghui Zhu,Qingcong Wu,Bai Chen,Ke Ye,Qiang Zhang
DOI: https://doi.org/10.1016/j.isatra.2024.06.011
IF: 7.3
2024-06-20
ISA Transactions
Abstract:Highlights • Different from the previous reconfigurable variable stiffness actuator (RVSA), the lightweight RVSA proposed in this paper has a more reasonable configuration of the pulley block and the drive motor, so that the actuator has a smaller mass and a compact structure. • Different from the traditional backstepping control method, this paper proposes a dynamic surface backstepping control method based on neural network and disturbance observer for the lightweight RVSA. The proposed method uses the dynamic surface method to avoid the "computation explosion" problem of traditional backstepping control. • In order to compensate for the lumped uncertainties and disturbances of the lightweight RVSA, an uncertainties and disturbances estimation method combining neural network and disturbance observer is proposed. Different from traditional estimators, the proposed estimator can simultaneously compensate for joint and motor uncertainties and disturbances. • Experiments and simulations were conducted under the condition of actively changing stiffness to verify the effectiveness of the proposed method. The requirements on the controller are more challenging compared to experiments in the quasi-static stiffness case. Reconfigurable variable stiffness actuator (RVSA) has attracted increasing attention in robotics due to its safety, compliance, and robustness. However, the control of the RVSA is challenging due to nonlinear factors such as high-order nonlinear dynamic, model uncertainties, time-varying model parameters, and disturbances. In this paper, firstly, a lightweight RVSA structure with both passive and active nonlinear variable stiffness characteristic is developed. Secondly, a dynamic surface backstepping control method based on a radial basis neural network and disturbance observer (DSBC-RBFNN-DOB) is proposed to achieve position control of the lightweight RVSA with matched and unmatched uncertainties. To address solve the "complexity explosion" and noise problems in traditional backstepping control, the dynamic surface backstepping control (DSBC) method is used to design the controller. Then, a method based on radial basis neural network (RBFNN) and disturbance observer (DOB) are used to compensate for the matched and unmatched uncertainties in the link and motor. In this method, the matched uncertainties are compensated using RBFNN, and the DOB is integrated to compensate RBFNN approximation errors and unmatched uncertainties. Through Lyapunov stability analysis, the semi-global boundedness of the controller is proven. Finally, the proposed method is simulated and actually implemented, verifying the effectiveness of the method. Simulation and experimental results show that the root mean square error (RMSE) of the proposed method is only 0.97277° and 0.6418°, respectively. Compared with PID, DSBC, and DSBC-RBFNN, the error reduction percentages in simulation (experiment) are 85.6% (88.9%), 49.4% (88.4%) and 36.1% (80.0%) respectively.
automation & control systems,instruments & instrumentation,engineering, multidisciplinary