Magnetic graphene derivates for efficient herbicide removal from aqueous solution through adsorption
Theodoro da Rosa Salles,Leonardo Vidal Zancanaro,Franciele da Silva Bruckmann,Wagner Jesus Garcia,Artur Harres de Oliveira,Luiza Baumann,Daniele Soares Basso Rhoden,Edson Irineu Muller,Diego Stefani Teodoro Martinez,Sergio Roberto Mortari,Cristiano Rodrigo Bohn Rhoden
DOI: https://doi.org/10.1007/s11356-024-32845-6
IF: 5.8
2024-03-14
Environmental Science and Pollution Research
Abstract:2,4-Dichlorophenoxyacetic acid (2,4-D) is an herbicide and is among the most widely distributed pollutant in the environment and wastewater. Herein is presented a complete comparison of adsorption performance between two different magnetic carbon nanomaterials: graphene oxide (GO) and its reduced form (rGO). Magnetic functionalization was performed employing a coprecipitation method, using only one source of Fe 2+ , requiring low energy, and potentially allowing the control of the amount of incorporated magnetite. For the first time in literature, a green reduction approach for GO with and without Fe 3 O 4 , maintaining the magnetic behavior after the reaction, and an adsorption performance comparison between both carbon nanomaterials are demonstrated. The nanoadsorbents were characterized by FTIR, XRD, Raman, VSM, XPS, and SEM analyses, which demonstrates the successful synthesis of graphene derivate, with different amounts of incorporate magnetite, resulting in distinct magnetization values. The reduction was confirmed by XPS and FTIR techniques. The type of adsorbent reveals that the amount of magnetite on nanomaterial surfaces has significant influence on adsorption capacity and removal efficiency. The procedure demonstrated that the best performance, for magnetic nanocomposites, was obtained by GO∙Fe 3 O 4 1:1 and rGO∙Fe 3 O 4 1:1, presenting values of removal percentage of 70.49 and 91.19%, respectively. The highest adsorption capacity was reached at pH 2.0 for GO∙Fe 3 O 4 1:1 (69.98 mg g −1 ) and rGO∙Fe 3 O 4 1:1 (89.27 mg g −1 ), through different interactions: π-π, cation-π, and hydrogen bonds. The adsorption phenomenon exhibited a high dependence on pH, initial concentration of adsorbate, and coexisting ions. Sips and PSO models demonstrate the best adjustment for experimental data, suggesting a heterogeneous surface and different energy sites, respectively. The thermodynamic parameters showed that the process was spontaneous and exothermic. Finally, the nanoadsorbents demonstrated a high efficiency in 2,4-D adsorption even after five adsorption/desorption cycles.
environmental sciences