Abstract:Ball passing frequencies (BPFs) are very important features for condition monitoring and fault diagnosis of rolling ball bearings. The ball passing frequency on outer raceway (BPFO) and the ball passing frequency on inner raceway (BPFI) are usually calculated by two well-known kinematics equations. In this paper, a systematic study of BPFs of rolling ball bearings is carried out. A novel method for accurately calculating BPFs based on a complete dynamic model of rolling ball bearings with localized surface defects is proposed. In the used dynamic model, three-dimensional motions, relative slippage, cage effects and localized surface defects are all considered. Moreover, localized surface defects are modeled accurately with consideration of the finite size of the ball, the additional clearance due to material absence, and changes of contact force directions. The reasonability of the proposed method for the prediction of dynamic behaviors of actual ball bearings with localized surface defects and for the calculation of BPFs is discussed by investigating the motion characteristics of a ball when it rolls through a defect. Parametric investigation shows that the shaft speed, external loads, the friction coefficient, raceway groove curvature factors, the initial contact angle, and defect sizes have great effects on BPFs. For a loaded ball bearing, the combination of rolling and sliding in contact region occurs, and the BPFs calculated by simple kinematical relationships are inaccurate, especially for high speed, low external load, and large initial contact angle conditions where severe skidding occurs. The hypothesis that the percentage variation of the spacing between impulses in a defective ball bearing was about 1–2% reported in previous investigations can be satisfied only for the conditions where the skidding effect in a bearing is slight. Finally, the proposed method is verified with two experiments.

A method for calculating and interpreting the ratio of friction force to normal force imparted on a spherical object: Application to a cricket ball during bowling

Calculation of the Point of Application (Centre of Pressure) of Force and Torque Imparted on a Spherical Object from Gyroscope Sensor Data, Using Sports Balls as Practical Examples

Identification of Spin Bowling Deliveries with an Advanced Smart Cricket Ball

Dynamic Characteristic Analysis of High-speed Spherical Ball Bearing

A Friction Evaluation Method Based on Barrel Compression Test

A Quasi-Dynamic Model for High-Speed Ball Spinning

A systematic study of ball passing frequencies based on dynamic modeling of rolling ball bearings with localized surface defects

Analysis of point-contact models of the bounce of a hard spinning ball on a compliant frictional surface

Using a Sensor-Embedded Baseball to Identify Finger Characteristics Related to Spin Rate and Pitching Velocity in Pitchers

Evaluation of Coefficients of Friction for Cylinders, Rolling Down an Inclined Plane, by a Facile Video Analysis Technique

Inter- and intra-athlete technique variability of conventional new ball swing bowling in elite and pre-elite Australian male fast bowlers

A Calculation Method of Bearing Balls Rotational Vectors Based on Binocular Vision Three-Dimensional Coordinates Measurement

Usage and acceptability of data normalization in baseball pitching

Estimation of Rolling Friction Coefficients in a Tribosystem Using Optical Measurements

Frictionless Racquetball?

Outer irregular satellites of the planets and their relationship with asteroids, comets and Kuiper Belt objects

Rolling friction measurement of slightly non-spherical particles using direct experiments and image analysis

Producing 3D friction loads by tracking the motion of the contact point on bodies in mutual contact

A GREY MODELLING METHOD FOR THE FRICTION TORQUE OF ANGULAR CONTACT BALL BEARINGS

Reliability and validity of the fulltrack AI application to determine cricket bowling line and length compared to 3D motion capture

A Generalisation of the Capstan Equation and a Comparison Against Kikuchi and Oden's Model for Coulomb's Law of Static Friction