Abstract:The aeroelastic response of lightweight low-speed aircrafts with slender wings under extreme flow turbulence intensity is not well understood. Experiments on a commercial unmanned aerial vehicle (UAV) with a 3 m wingspan and aspect ratio of 13.6 were performed in a large open-return wind tunnel with extreme flow turbulence intensity of ≈10%. The wing bending displacement and the flow beneath the wing were measured by using laser-displacement sensors and tomographic particle image velocimetry (PIV) techniques, respectively. The unsteady lift produced by the wing was also measured by using a high-capacity load cell at an angle of attack of two degrees for three freestream velocities of 13.4 m/s, 17.9 m/s, and 26.8 m/s, representing the UAV's stall speed, a speed approximately equal to the cruise speed, and a speed considerably higher than the cruise speed, respectively. It was found that a high flow turbulence intensity with large integral length scales relative to the wing chord plays a dominant role in the large unsteady lift and wing displacements measured. The power spectral density (PSD) of the wing structural vibration shows that flow shedding from the wing and the integral length scales have a significant impact on the overall power inherent in the bending vibration of the wing. Computations of the vorticity isosurfaces in the flow measurement volume surrounding the aileron reveal a striking observation: an aileron deflection of 10° becomes less effective in producing additional spanwise vorticity, which is proportional to circulation and lift at 26.8 m/s since the freestream already has elevated levels of vorticity. A paradigm shift in design is suggested for light aircraft structures with slender wings operating in highly turbulent flow, which is to employ multiple control surfaces in order to respond to this flow and mitigate large bending or torsion displacements and the probability of structural failure.

Numerical investigation of forces and acceleration for air-sea unmanned aerial vehicle in transition

Computational Fluid Dynamics Study of Autonomous Underwater Vehicle with Vectorial Thrusters

Formulations of Hydrodynamic Force in the Transition Stage of the Water Entry of Linear Wedges with Constant and Varying Speeds

The Shape Design Optimization Simulation of Quadrotor Unmanned Underwater Vehicle for Drag Reduction

Computational simulation of a submersible unmanned aerial vehicle impacting with water

Research on Hydrodynamics of Trans-Media Vehicles Considering Underwater Time-Varying Attitudes

Numerical Study on the Water Entry of a Freely Falling Unmanned Aerial-Underwater Vehicle

Computational fluid dynamics analysis of aerodynamic characteristics in long-endurance unmanned aerial vehicles

Simulation research on water-entry impact force of an autonomous underwater helicopter

Hydrodynamic Performance Of A Flapping Wing Based Auv-A Numerical Study

Hydrodynamic Analysis and Drag-Reduction Design of an Unmanned Underwater Vehicle Based on Computational Fluid Dynamics

Lift–Drag Performance of a New Unmanned Aerial Vehicle in Different Media and Ground Effect

Aerodynamic Numerical Simulation Analysis of Water–Air Two-Phase Flow in Trans-Medium Aircraft

Numerical research on the high-speed water entry trajectories of AUVs with asymmetric nose shapes

Basic Research on the Influence of Descent Flow From Small Unmanned Aerial Vehicle (Quadcopter) on a Small Floating Body

Computational fluid dynamic analysis of an unmanned amphibious aerial vehicle for drag reduction

CFD-Based Lift and Drag Estimations of a Novel Flight-Style AUV with Bow-Wings: Insights from Drag Polar Curves and Thrust Estimations

Research of a novel aerodynamic evaluation method for fixed-wing UAV

Numerical Investigation on Hydrodynamic Performance of a Portable AUV

Numerical study on the water entry of two-dimensional airfoils by BEM

Experiments of Lift-Bending Response on a Slender UAV Wing Structure with Control Surface under Extreme Flow Turbulence