Real‐time precise orbit determination for FY‐3C and FY‐3D based on BDS and GPS onboard observation

Zhiyu Wang,Liang Wang,Zishen Li,Mainul Hoque,Ningbo Wang,Dongyan Wei,Hong Yuan
DOI: https://doi.org/10.1049/rsn2.12413
2023-05-11
IET Radar, Sonar & Navigation
Abstract:(1) The real‐time precise orbit determination (POD) for low earth orbit (LEO) satellites based on spaceborne global positioning system (GPS) and BDS‐2 observations are executed. (2) Code multipath piece‐wise linear (PWL) error model of BDS‐2 satellites is constructed and applied to real‐time LEO POD. The performance of real‐time LEO POD is enhanced after applying a BDS‐2 code multipath PWL error model. (3) The average accuracy of the real‐time POD for FY‐3C/FY‐3D utilised spaceborne GPS + BDS‐2 (without geostationary earth orbit) data is optimal (6.11/5.95 cm) and better than only using spaceborne GPS data. The code multipath error associated with elevation in BDS‐2 is one of the main factors whose impact on the precision of real‐time reduced‐dynamic precise orbit determination (POD) using spaceborne multi‐global navigation satellite systems (GNSS) observation data for FengYun‐3C (FY‐3C) and FengYun‐3D (FY‐3D) satellites. The aim is to construct a code multipath piece‐wise linear error model and analyse the contribution of BDS‐2 to the performance of low earth orbit POD. Conclusions are drawn out from the experimental results: (1) the real‐time POD average precision of FY‐3C and FY‐3D is improved by about 11% and 12% after the correction of BDS‐2 code multipath error; (2) Due to the small number of available BDS‐2 satellites and the limited accuracy of geostationary earth orbit (GEO) satellite real‐time orbit products, the precision of the real‐time overlapping comparison for FY‐3C/FY‐3D by using the BDS‐2 onboard observation data can only reach the decimetre level. However, with the BDS‐2 signal capture capability of the FY‐3D onboard GNSS Occultation Sounder upgraded, the average precision of the BDS‐2‐based POD for FY‐3D is better than that of FY‐3C in each direction and with 10% improvement in the average 3 dimensional‐root mean square (3D‐RMS); (3) Cases of onboard global positioning system (GPS), GPS + BDS‐2 (with GEO), and GPS + BDS‐2 (without GEO) for real‐time POD can meet 5–8 cm precision requirement. The average 3D‐RMS of the real‐time POD for FY‐3C/FY‐3D, which utilises onboard GPS + BDS‐2 data is inferior only to GPS data, owing to the influence of the orbit accuracy of GEO satellites. However, after excluding the influence of GEO satellites, the average result (3D‐RMS) of the real‐time POD for FY‐3C (6.11 cm) and FY‐3D (5.95 cm) is better than those of other cases.
telecommunications,engineering, electrical & electronic
What problem does this paper attempt to address?