Abstract:Abrasive water jet (AWJ) is a type of cold processing technology, and there are many factors affecting its machining effect. In this paper, a coupled Finite Element Methods-Smoothed Particle Hydrodynamics (FEM-SPH) numerical model was established to investigate the key influencing factors of AWJ machining ductile materials. The abrasive particles in the model were shaped as irregular polyhedrons, and the material properties of the abrasive particles as well as the influence mechanism of the fluid–structure interaction between the abrasive particles and the water were considered. The relative error range of experimental measured results and simulation predicted results is 22.77%–36.55%. Then, the effects of content and distribution of abrasive particles, the jet working pressure P, the traverse rate of nozzle V t r a v and the impingement angle α were systematically and quantitatively evaluated through two-way verification of experiments and simulations. It was found that: (i) Effects of stand-off distance (SOD) on the kerf profile and the quality of kerf surface was essentially determined by the content and distribution of abrasive particles. As the increase of SOD, the jet divergence gradually increases, and the kerf profile gradually changes from “U-shaped” to “V-shaped”. (ii) Experiments and simulations demonstrate that the P has a linear increasing relationship with the maximum depth h of kerf profile, and the V t r a v has a linear decreasing relationship with the maximum depth h, while it has a linear increasing relationship with the jet trailing angle β , which was independent of the ductile material type. (iii) The combined effect of V t r a v and α affects geometric parameters and surface quality of the kerf profile, under the same P, the depth of the cut surface obtained by backward cutting is only 72.1% of that of the forward cutting, while the quality of the cut surface of former one is higher than the latter one.

Comparison of Continuous and Pulsating Water Jet during Piercing of Ductile Material

Submerged pulsating water jet erosion of ductile material

Comparison of ultrasonically enhanced pulsating water jet erosion efficiency on mechanical surface treatment on the surface of aluminum alloy and stainless steel

Surface removal of ductile metal using cyclic low-frequency impact of a discrete particle-less waterjet

Potential of pulsed water jets for cutting and fracturing of hard rock formations

Evaluation of the Depth and Width of Cuts after Controlled-Depth Abrasive Water Jet Machining Using Low Pressure

Erosion development in AISI 316L stainless steel under pulsating water jet treatment

Ultrasonic Pulsating Water Jet Peening: Influence of Pressure and Pattern Strategy

An In-depth Investigation on Kerf Angle in Pierced Hole on Inconel-625 Superalloy using Abrasive Waterjet Cutting Process

Utilizing the water hammer effect to enhance the mechanical properties of AISI 304 welded joints

Standoff Distance in Ultrasonic Pulsating Water Jet

Research on Flow Field Characteristics in Water Jet Nozzle and Surface Damage Caused by Target Impact

Experimental and simulation study on the influence factors of abrasive water jet machining ductile materials

Utilising of water hammer effect for surface roughening of Ti6Al4V

Experimental Study on the Surface Property Changes of Aluminum Alloy and Stainless Steel after Impingement with Submerged Cavitation Jet

The internal failure of rock samples subjected to pulsed water jet impacts

Study on Process and Mechanism of Laser Drilling in Water and Air

An Experimental Investigation on Machining of Hardened AISI 440C Stainless Steel Using Abrasive Water Jet Machining Process

The effect of cutting jet variation on striation formation in abrasive water jet cutting

Experiments of Main Parameters Affecting the Erosive Behavior of Self-Excited Oscillating Abrasive Water Jets: Length of Self-Oscillation Chamber, Jet Pressure, Abrasive Fluid Velocity, and Abrasive Grain Size

Effect of Waterjet Machining Parameters on the Cut Quality of PP and PVC-U Materials Coated with Polyurethane and Acrylate Coatings