Abstract:Proceedings of the Institution of Mechanical Engineers, Part E: Journal of Process Mechanical Engineering, Ahead of Print. According to the statistical results of the reciprocating compressor maintenance in chemical enterprises, the probability of faults caused by wear or damage of vulnerable parts inside the cylinder is close to 80%. Now, fault diagnosis of vulnerable parts inside the cylinder is relied on vibration signal, acoustic emission signal, or thermal parameters. However, it is difficult to extract eigenvalues from vibration signals and acoustic emission signals, which can be disturbed by noise easily. Thermal parameters are relatively stable and less affected by noise. The measurement of thermal parameters requires drilling testing holes through the cylinder wall, which will decrease the strength of the cylinder. According to the working principle of the compressor, fault of the vulnerable parts inside the cylinder would change the pressure and temperature distribution at the suction and the discharge port of the cylinder, while these state parameters are monitored by the parameter monitoring system on most of the compressors. For these reasons, a fault prediction model based on state parameters learning is proposed in this paper aiming to fault diagnosis of vulnerable parts inside the cylinder, which could make fault prediction without adding new hardware cost, such as sensors. Optimized back propagation neural network method by genetic algorithm (GA-BP) is applied to establish the fault prediction model to describe normal working process of the compressor. When fault of vulnerable parts inside the cylinder occurs, monitored pressure and temperature would deviate from the predicted value by the fault prediction. The degree of the deviation is adopted to the fault diagnosis. Then, experiments simulating the fault condition were carried out, and it shows that the accuracy of fault diagnosis using this method could exceed 95%. Verification test shows that the proposed method could successfully predict the fault before the unplanned shutdown.

Research on reliability of centrifugal compressor unit based on dynamic Bayesian network of fault tree mapping

Dynamic Bayesian Network for Robust Latent Variable Modeling and Fault Classification

Air conditioning reliability analysis based on dynamic Bayesian network and Markov model

Reliability Analysis of Electrical System of Computer Numerical Control Machine Tool Based on Bayesian Networks

Research on Fault Diagnosis Technique of Vulnerable Parts in Reciprocating Compressor Cylinder Based on p-V Diagram Characteristics-Fault Diagnosis Model

A discrete-time Bayesian network approach for reliability analysis of dynamic systems with common cause failures

An Approach for the Dynamic Reliability Assessment of the Digital Power Control System for Nuclear Reactor

A novel fault measure and early warning system for air compressor

Reliability Analysis of Subsea Control Module based on Dynamic Bayesian Network and Digital Twin

A Dynamic Reliability-Centered Maintenance Analysis Method for Natural Gas Compressor Station Based on Diagnostic and Prognostic Technology

Reliability analysis for manufacturing system of drive shaft based on dynamic Bayesian network

Reliability Modeling and Evaluation for Rectifier Feedback System Based on Continuous Time Bayesian Networks under Fuzzy Numbers

Research on the Fault Diagnosis Method of Reciprocating Compressors Based on the Probability Diagram Model

Application of state parameter learning for fault diagnosis on the large reciprocating compressor

A Dynamic Rcm Analysis Method For Natural Gas Compressor Station Based On Diagnostic And Prognostic Technology

Reliability Analysis Based on Dynamic Bayesian Networks: A Case Study of an Unmanned Surface Vessel

Research on Fault Diagnosis of Steam Turbine Based on Bayesian Network

System Reliability Modeling and Assessment for Solar Array Drive Assembly Based on Bayesian Networks

The fault diagnosis for centrifugal compressor based on time series analysis with neutral network

Bayesian Reliability Evaluation Method for the Rotor

Study on Reliability of Control System in Deepwater CBHP MPD System