Water Vapour assisted machining of Inconel 718 incorporating through-tool cutting fluid delivery approach

Ganesh S. Kadam,Raju S. Pawade

DOI: https://doi.org/10.1007/s12008-023-01335-3

2023-04-29

International Journal on Interactive Design and Manufacturing

Abstract:Present manufacturing norms globally demand usage of sustainable practices by the machining firms. There is also demand for better product quality and higher production rates with constraints on cost. The superalloy Inconel 718 finds plenty of applications in aerospace, automobiles, chemical plants and power plants. However it poses lot of challenges in machining due to its difficult-to-cut characteristics. To address these issues, the current paper explores the high-speed turning of Inconel 718 using coated carbide inserts and the eco-friendly cutting fluid as water vapour. The novelty of the work lies in use of very minutely explored eco-friendly cutting fluid as water vapour, use of unique tool holder with integrated cutting fluid delivery channel for precise jetting at tool-work interface, incorporation of high-speed machining regime for better productivity, use of economic carbide tooling as opposed to the costly ceramics and CBNs, and thus implementing sustainability in machining. Central composite design based on response surface methodology was used for experimentation as the process parameters were limited and their exploratory ranges already known. This also enabled to study effect of multiple factors simultaneously with fewer experimental combinations. Cutting speed, feedrate and pressure of water vapour was varied in the range of 72.96-157.04 m/min, 0.05–0.15 mm/rev and 0.20–0.70 bar respectively. The machinability characteristics have been assessed in terms of chip deformation coefficient, cutting forces and mainly surface roughness. Increase of pressure led to reduction in chip deformation coefficient, cutting forces and surface roughness on account of better water vapour penetrability into machining zone. However increase of feedrate led to higher values of cutting force and surface roughness. The feedrate and pressure were found to be highly dominating factors influencing the surface roughness with their contribution being 18.29% and 58.23% respectively. Analysis of micrographs of machined surfaces revealed presence of surface alterations consisting of feedmarks, grooves, micro-particle deposits and material side-flow to variable extends depending on machining conditions.