High‐Efficiency ZnO‐Based Ultraviolet Photodetector with Integrated Single‐Walled Carbon Nanotube Thin‐Film Heater

Jeong‐Hyeon Kim,Jongyun Choi,Hyunseok Na,Sung‐Nam Lee
DOI: https://doi.org/10.1002/admi.202300176
IF: 5.4
2023-04-20
Advanced Materials Interfaces
Abstract:A single‐walled carbon nano‐tube (SWCNT) heater is added to sol‐gel ZnO‐based ultraviolet Photodetectors (PD)s to improve poor photoreaction. The transparent SWCNT heater is fabricated by spin coating, with response time of <1 min. The PDs showed 137% increase in photocurrent when the SWCNT heater temperature rose from 25 to 112 °C, and the rise and decay times significantly shortened. Recently, sol–gel‐derived ZnO thin films have been explored for high performance photodetectors (PDs). However, the crystallinity of sol–gel‐derived ZnO films is inferior to vacuum‐based grown ZnO film, leading to poor photoreaction in the PDs. This study combines a single‐walled carbon nanotube (SWCNT) heating system with sol–gel ZnO‐based ultraviolet (UV) PDs. A SWCNT heater is fabricated on sapphire substrates using spin coating technique, resulting in a transparent heater with a transmittance of ≈80% by controlling spin speed. In addition, increasing the number of SWCNT spin coatings from 1 to 3 raises the heater temperature to over 170 °C, resulting in a response time of less than 1 min. The sol–gel ZnO‐based UV PDs with the SWCNT heater shows a 137% increase in photocurrent as the SWCNT heater temperature increases from 25 to 112 °C. In addition, the increase in temperature of the embedded‐SWCNT heater significantly shortens the rise and decay times of the sol–gel‐derived ZnO PDs.
materials science, multidisciplinary,chemistry
What problem does this paper attempt to address?