Abstract:This study explores the performance optimization of grooved heat pipes under rotational conditions, focusing on both straight and curved designs. To address the challenges posed by centrifugal forces in rotating systems, we designed and tested a conventional straight grooved heat pipe and a novel curved grooved heat pipe with a variable curvature structure. Experiments were conducted across a range of rotational speeds (0-20 rpm), heat loads (30 W-300 W) and loading methods (heat load before rotation and heat load after rotation) to evaluate the operating performance of both grooved heat pipes. The results indicate that the straight grooved heat pipe struggled to maintain efficiency under rotational conditions, as centrifugal forces caused fluid to accumulate at both ends, leading to higher operating temperatures and reduced heat transfer efficiency. At the case of 20 rpm with a heat load of 110 W, the temperature difference exceeded 25 degrees C, highlighting the limitations of the straight design in such environments. In contrast, the curved grooved heat pipe effectively mitigated the impact of centrifugal forces. Its design reduced liquid accumulation in the condenser section, maintained beneficial acceleration effects in the evaporator section, and improved overall heat transfer performance. Specifically, at 20 rpm, the curved pipe successfully transferred over 300 W with a temperature difference not exceeding 5 degrees C, demonstrating its superior performance. However, at higher rotational speeds and lower power levels, the curved design also showed some limitations, as excessive fluid accumulation in the evaporator section led to a shift in the evaporation site, increased thermal resistance, and a certain degree of superheating. These findings highlight the potential of the variable curvature design in improving the efficiency of grooved heat pipes under rotational conditions. This work advances the understanding of fluid dynamics and heat transfer mechanisms in such systems, offering insights that could inform the design of more efficient heat pipes for rotating applications.

Thermal performance of heat pipe at different internal groove ratios and working fluids: An experimental investigation

Design and analysis of grooved heat pipe

Experimental Study on Steady-State Performance of an Axial Grooved Heat Pipe under Rotational Condition

Heat Transfer Capacity Optimization Design of Microgroove and Microcolumn in an Ultra-Thin Flat Heat Pipe

Rotating Heat Pipe Performance with Internal Wire Mesh Screens

Design and Experimental Analysis of Grooved Flat Aluminum Heat Pipe

Experimental Investigation of Thermal Conduction Performance on Silicon-Based Micro Flat Heat Pipe

Corner Flow Characteristics in a Silicon-Based Ultra-Thin Flat-Grooved Heat Pipe with Double-End Cooling

Effects of filling ratio, geometry parameters and coolant temperature on the heat transfer performance of a wraparound heat pipe

Experimental and theoretical investigation of the influence of heat transfer rate on the thermal performance of a multi-channel flat heat pipe

Characterization of internal thermohydraulic flow and heat transfer improvement in a three‐dimensional circular corrugated tube surfaces based on numerical simulation and design of experiment

Impact of Microgroove Shape on Flat Miniature Heat Pipe Efficiency

Effect of evaporation and condensation section length ratio on thermal performance of aluminum flat plate heat pipe with different micro grooved wicks

Experimental study on heat transfer performance of axially rotating heat pipe in steady state

Experimental investigation on thermal characteristics of flat miniature axially grooved heat pipes

Experiments and comparisons of three miniature heat pipes' thermal performance

Experimental investigation on thermal performance of pulsating heat pipe by using Dowtherm – A

EXPERIMENTAL STUDY ON IMPROVING HEAT TRANSFER ABILITY OF A HEAT PIPE UTILIZING IRON OXIDE-FERRIC OXIDE HYBRID AND NICKEL FERRITE MONO-MAGNETIC NANOFLUIDS

Thermal Characterisation of Micro Flat Aluminium Heat Pipe Arrays by Varying Working Fluid and Inclination Angle

Analyses and estimation of certain design parameters of micro-grooved heat pipes

Three-Dimensional Numerical Analysis of Mini-Grooved Flat Heat Pipe Filled with Different Working Fluids with Experimental Validation