Abstract:Solar Salt, a molten nitrate salt, plays a crucial role in heat transfer and storage within solar thermal power plants. It helps to mitigate power output fluctuations resulting from changes in sunlight. Additionally, it allows nuclear power plants with thermal energy storage adjusting power output to better meet grid demand, all without altering reactor power. Maintaining the stability of Solar Salt is vital for ensuring the efficiency and cost-effectiveness of these operations. A study was conducted by subjecting fresh Solar Salt to pre-heating at temperatures surpassing the typical operational limits, referred to as the precondition phase, of the Natrium™ Demonstration nuclear plant being built with TerraPower, LLC and GE-Hitachi technology. Subsequently, the focus centered on examining the thermal stability of the preconditioned molten salt under the maximum operating conditions within the ambient atmospheric environment. The preconditioned molten salt, kept at 540 °C for 10 days, consistently exhibited minimal daily mass loss rates at its maximum operating temperatures of 480 and 510 °C, in contrast to the unpreconditioned salt, where initial daily rates were higher and then gradually decreased over time. Furthermore, the molar ratios of nitrite to nitrate ions in the preconditioned salt melts decreased and eventually stabilized at equilibrium states under these maximum operating temperatures. The equilibrium concentrations in the preconditioned melts approached those of the unpreconditioned melts, where nitrite/nitrate ratios increased and eventually stabilized. During the decomposition of both preconditioned and unpreconditioned melts, oxide formation gradually increased but did not reach an equilibrium state. However, the preconditioned melts exhibited lower rate constants at temperatures of 480 °C and 510 °C over time. The onset of melting temperature, initially recorded at 211 °C for the preconditioned 480 and 510 °C melts, gradually increased as the nitrite/nitrate ratios decreased over time, ultimately achieving stability. In contrast, the unpreconditioned 480 and 510 °C melts experienced a gradual decline from 221 °C in their melting points until they reached equilibrium. In , the preliminary treatment of Solar Salt at temperatures exceeding the maximum operation temperatures serves to eliminate impurities and enhance the stability of the molten salt. This preparatory step is essential when using molten nitrate salt as a medium for transferring thermal energy from the sodium cooling loops to the steam generation process in nuclear power plants with thermal energy storage.

Investigation on thermal performance of eutectic binary nitrate-carbonate molten salt under thermal shock condition

Experimental Study On Thermal Performance Of Mixed Nitrate And Carbonate Salts

Investigation on thermal performance of quinary nitrate/nitrite mixed molten salts with low melting point for thermal energy storage

Experimental Study on the Thermal Stability of a New Molten Salt with Low Melting Point for Thermal Energy Storage Applications

Thermal Performance of a Binary Carbonate Molten Eutectic Salt for High-Temperature Energy Storage Applications

Design of new molten salt thermal energy storage material for solar thermal power plant

Experimental study on optimized composition of mixed carbonate salt for sensible heat storage in solar thermal power plant

Preparation And Experimental Study Of Mixed Carbonates With High Maximum Using Temperature

Preparation and Thermal Properties of Quaternary Mixed Nitrate with Low Melting Point

Thermal performance and economic evaluation of NaCl–CaCl2 eutectic salt for high-temperature thermal energy storage

Experimental Test of Properties of KCl–MgCl2 Eutectic Molten Salt for Heat Transfer and Thermal Storage Fluid in Concentrated Solar Power Systems

Eutectic Na2CO3–NaCl Salt: A New Phase Change Material for High Temperature Thermal Storage

Thermodynamic calculations and experimental studies of ternary molten salts for high-temperature thermal energy storage

A Novel High Temperature Eutectic Salt and Its Composite with Enhanced High Conductivity

Thermal transport and storage performances of NaCl–KCl–NaF eutectic salt for high temperatures latent heat

Thermal property characterization of a low melting-temperature ternary nitrate salt mixture for thermal energy storage systems

Characterization and Heat Transfer Performance of Quarternary Nitrate Based Molten Salts

Novel Wide-Working-Temperature NaNO3-KNO3-Na2SO4 Molten Salt for Solar Thermal Energy Storage

Survey and evaluation of equations for thermophysical properties of binary/ternary eutectic salts from NaCl, KCl, MgCl2, CaCl2, ZnCl2 for heat transfer and thermal storage fluids in CSP

Experimental study on optimized composition of mixed carbonate for phase change thermal storage in solar thermal power plant

Effect of pre-heating on thermal stability of molten nitrate salt