Abstract:Purpose Temperature is a critical factor in the fused filament fabrication (FFF) process, which affects the flow behavior and adhesion of the melted filament and the mechanical properties of the final object. Therefore, modeling and predicting temperature in FFF is crucial for achieving high-quality prints, repeatability, process control and failure prediction. This study aims to investigate the melt deposition and temperature profile in FFF both numerically and experimentally using different Acrylonitrile Butadiene Styrene single-strand specimens. The process parameters, including layer thickness, nozzle temperature and build platform temperature, were varied. Design/methodology/approach COMSOL Multiphysics software was used to perform numerical simulations of fluid flow and heat transfer for the printed strands. The polymer melt/air interface was tracked using the coupling of continuity equation, equation of motion and the level set equation, and the heat transfer equation was used to simulate the temperature distribution in the deposited strand. Findings The numerical results show that increasing the nozzle temperature or layer thickness leads to an increase in temperature at points close to the nozzle, but the bed temperature is the main determinant of the overall layer temperature in low-thickness strands. The experimental temperature profile of the deposited strand was measured using an infrared (IR) thermal imager to validate the numerical results. The comparison between simulation and observed temperature at different points showed that the numerical model accurately predicts heat transfer in the three-dimensional (3D) printing of a single-strand under different conditions. Finally, a parametric analysis was performed to investigate the effect of selected parameters on the thermal history of the printed strand. Originality/value The numerical results show that increasing the nozzle temperature or layer thickness leads to an increase in temperature at points close to the nozzle, but the bed temperature is the main determinant of the overall layer temperature in low-thickness strands. The experimental temperature profile of the deposited strand was measured using an IR thermal imager to validate the numerical results. The comparison between simulation and observed temperature at different points showed that the numerical model accurately predicts heat transfer in the 3D printing of a single-strand under different conditions. Finally, a parametric analysis was performed to investigate the effect of selected parameters on the thermal history of the printed strand.

Numerical simulation and image analysis of thermal behavior of spacer fabric

A Numerical Simulation on Heat Transfer of Fabric Based on the Yarn Interweaved Structure

Simulation of Heat Transfer Through Woven Fabrics Based on the Fabric Geometry Model

Research progress of numerical simulation on heat and moisture transfer in porous textiles

Heat Transfer Through Glassfiber Fabrics Coated with Silicone Resin

Simulation Investigation of Effects of Structural Density on the Thermal Insulation Property of Glass Fiber Fabric

Simulation of the Effects of Structural Parameters of Glass Fiber Fabric on the Thermal Insulation Property

Investigation of Automated Geometry Modeling Process of Woven Fabrics Based on the Yarn Structures

Effects of Structural Parameters on the Thermal Insulation Properties of Coated Carbon Fiber Fabrics

Numerical simulation and experiment verified for heat transfer processes of high-property inorganic fiber woven fabrics

Thermal and water vapor transmission through porous warp knitted 3D spacer fabrics for car upholstery applications

Heat transfer simulation through textile porous media

Temperature and density distribution in an industrial stenter frame based on three-dimensional numerical simulation

Thermo-acoustic behaviour of 3D knitted spacer fabrics

Numerical Simulation of the Passive Radiative Cooling Fabric Based on Fiber‐Yarn‐Texture‐Doping Particle 3D Model

Simulation of temperature profile in fused filament fabrication 3D printing method

Three-dimensional simulation of heat and moisture transfer in woven fabric structures

Providing thermal exchange when designing special clothing

Dynamic Heat Transfer Simulation in Textile for Practical Application: A Comparative Analysis of Microscopic and Macroscopic Approaches

Finite element parameterization modeling and thermal performance analysis for woven fabrics using unit cell models

Asymmetric Thermal and Water Vapor Transport of Polyester Spacer and Cotton Nonwoven Fabric Assembly