Comparison of acetabulum related parameters in different planes on CT images
Hao Wu,Weijun Wang,Minghui Sun,Wenjie Weng
DOI: https://doi.org/10.3877/cma.j.issn.1674-134X.2016.01.005
2016-01-01
Abstract:Objective To investigate the differences of acetabulum related parameters between the horizontal plane and true pelvis plane on CT images , and explore the impact on the operation .Methods The hip CT images of 80 normal cases in Affiliated Drum Tower Hospital ,Nanjing University ,were collected with natural supine position .Inclusion criteria:CT images contain all the pelvises , acetabula and femoral heads;no obvious pathological change in the acetabula ,femoral heads and sacroiliac joints; the inspected patients with no forced postures when scanning .Exclusion criteria: ankylosing spondylitis or other spine , hip and knee fixed deformity diseases; forced postures because of the emergency diseases; a history of trauma or fracture.There were 44 males,36 females,average age was (40 ±6) years (18-55 years).The direction of CT scanning was perpendicular to the horizontal plane .Bilateral acetabular anteversion angle , abduction angle ,center-edge angle ( CE angle ) , acetabular width , acetabular depth and acetabular angle were measured ,as well as the angle between the true pelvis plane and horizontal plane .All the CT images were performed three-dimensional reconstruction ,then the images were collected with the scanning direction perpendicular to the true pelvis plane .The same parameters were measured .Paired t test was used to compare the differences of the outcomes between the left and right sides of the acetabulum ,as well as the ones between the two reference planes .Group t test was adopted to compare the differences of parameters between male and female .Spearman correlation analysis was performed to indicate the association of the parameters differentials and the reference planes angle .P <0.05 was considered as significant difference . Results There was no significant difference between the parameters of the two sides of the acetabulum in both reference planes (in horizontal plane:t=-0.06,-0.75,-0.33,-1.24,0.62,0.14,P>0.05), (in true pelvis plane t=1.58,0.47,1.19,-1.25,0.27,0.36,P>0.05).Statistical significance was detected between the genders .In horizontal plane , the abduction angle , acetabular width and depth were remarkably higher in male (t =-4.01,-6.69,-7.19,P<0.01),and acetabular angle was higher in female (t=3.49,P <0.01).The pelvic tilt was positively correlated with the difference of acetabular anteversion angle and CE angle ( r =0.49、0.29;P <0.05 ) , and was negatively correlated with the difference of acetabulum depth and angulus acetabularis ( r=-0.29,-0.22; P<0.05).Conclusion Traditional CT measurement of acetabulum parameters may result in errors , so more attentions should be paid during the pre-operative planning by the surgeons .