Improving the combustion of scramjet engines with struts using grooves and bumps
Zhi-Qiang Sheng,Lan Zhang,Liang-Ze Lu,Jing-Yuan Liu,Xiao-An Hu
DOI: https://doi.org/10.1016/j.ast.2024.109047
IF: 5.457
2024-03-15
Aerospace Science and Technology
Abstract:Grooves and bumps are arranged on both sides of a normal strut (NS) to fabricate vortex generators, and introduce streamwise vortices. Struts with sawtooth grooves (GS-1), rectangular bumps (BS-1), and trapezoidal and triangular bumps (BS-2) have been proposed. In this study, struts with V-shaped grooves (GS-2) and trapezoidal and triangular bumps (BS-3) were configured. The flow fields in the cold and hot states of scramjet combustors with NS, GS-1, GS-2, BS-1, BS-2, and BS-3 were simulated numerically using steady RANS equations and an SST k - ω turbulence model. The results show that proper arrangement of the grooves and bumps on the strut can improve the mixing and combustion performance. Compared with the NS, for GS-1, GS-2, BS-1, BS-2, and BS-3, the distance required to achieve 100% fuel mixing efficiency is shorter by 21.2%, 9.1%, 18.2%, 12.1%, and 15.2%, respectively, and to achieve 100% combustion efficiency, the distance is shorter by 42.7%, 46.9%, 47.9%, 53.1%, and 58.3%, respectively. Therefore, improvement in combustion performance does not positively correlate with improvement in the mixing performance. Large-scale heat and mass convection in streamwise vortices play a dominant role in mixing. The larger the proportion of the fuel area affected by the streamwise vortices, the more conducive it is to achieving a higher mixing performance, whereas the wall has a negative impact. However, the large-scale heat and mass convection in the streamwise vortices and small-scale heat and mass convection in the high-turbulence zones are closely related to the supply of oxygen and fuel required for the combustion zone. Large-scale streamwise vortices combined with thick high-turbulence zones are conducive to achieving a high combustion rate. When the recirculation zone has a larger combustion area and smaller wall effects, a higher combustion performance is easily achieved. Compared with the grooves, the stronger disturbance effect of the bumps on the fluid effectively increased the thickness of the high-turbulence zone, thus obtaining a higher combustion performance. However, the greater blocking area and new oblique shockwaves generated by the bumps induced a greater total pressure loss. Therefore, combining bumps and grooves can further optimize strut configurations.
engineering, aerospace