Abstract:A magnetorheological (MR) brake under compression-shear mode is designed, simulated and experimentally investigated in this paper. A MR brake under compression-shear mode was first designed considering compression enhanced shear yield stress of MR fluid. Then, the operating principle of the MR brake was illustrated and mathematical torque expressions, operating under compression-shear mode assuming Herschel–Bulkley model, was further established. Moreover, simulation analysis of the designed magnetic circuit was performed as well. An experimental prototype was fabricated and tested to evaluate the transmission performance of MR brake. The results showed that the large torque could be produced at high applied currents, high compressive stress, large compressive strain and small initial gap distances. The rotational speed and compressive speed had little effect on the torque. The characteristic rising time of the torque was greatly affected by the rotational speed, the compressive strain, and compressive speed. However, the current had little effect on the rising time. The time constant would became shorter when both the rotational speed and the compressive speed were faster. Through analyzing the compression of particle chains in MR fluids directly, it was found that the diameter and the length of the particles chains brought a strong influence on the essential property of MR fluids under compression. Thus, the compressive stress or compressive strain and the initial gap distance also played an important role in enhancing the torque. The results also showed that the proposed MR brake could generate a maximum torque of 241 Nm, about 17.9 times the magnitude of braking torque without compression, and achieve a high torque density of 125.6 kN m–2 and a time constant of 58 ms. This study provides a better understanding of MR brake under compression-shear mode and the implications for many high-power applications.

Two-wheeler magnetorheological drum brake operating under hybrid mode for enhancing braking torque: Development and validation

Tribological and braking performance study of additive-based MR fluids in shear and hybrid mode using MR drum brake

Experimental Investigations on the Nonlinear Dynamics of Magnetorheological Dampers

Study of a magnetorheological brake under compression-shear mode

Comparison of performance and tribological properties of electromechanical brake with magnetorheological fluid and magnetic powder

A performance evaluation of an automotive magnetorheological brake design with a sliding mode controller

Experimental investigations and characterization of shear and squeeze mode magnetorheological brake

A new design of small-sized magnetorheological brakes based on the mixed mode operation for high torque efficiency

Design, testing and analysis of a novel automotive magnetorheological braking system

A Novel Emergency Braking Control Strategy for Dual-Motor Electric Drive Tracked Vehicles Based on Regenerative Braking

Dynamic Characteristics and Modeling of A New Magnetorheological Damper for Broadband Vibration Control

The Magnetorheological Fluid: Testing on Automotive Braking System

A Novel Anti-Lock Braking Strategy for High Speed Light Weight Dual-Motor Electric Drive Tracked Vehicles

Design and optimization of squeeze-shear mode MR brake with multi-fluid flow channels based on Multi-objective sooty tern optimization algorithm

A linear magnetorheological brake with multipole outer coil structure for high on-state and low off-state force outputs

Magnetorheological and Wedge Mechanism-Based Brake-by-Wire System with Self-Energizing and Self-Powered Capability by Brake Energy Harvesting

Study of Effect of Graphite Based Magnetorheological Fluids on Braking Performance and Rotor Surface of Magnetorheological Disk Brake Using Full-Scale Brake Inertia Dynamometer

In-situ braking torque and temperature analysis of two-wheeler drum brake in friction braking

An experimental study on torque characteristics of magnetorheological brake with modified magnetic core shape

Design and Development of Cylindrical MR Fluid Brake with Multi-Coil Structure

Simulation-based estimation of an automotive magnetorheological brake system performance