Abstract:Submerged floating tunnel (SFT) is a new type of cable-supported structure system for strait crossing. Once the local anchor-cable suddenly fails, it will inevitably cause evident vibration and internal force redistributions of the structure. In order to study the dynamic responses and mechanical behaviors of the SFT subjected to abrupt anchor-cable breakage, a model test is conducted by a set of sensors installed on SFT for cable force, tube displacement and strain measurements. The transient dynamic signals following cable failure are tested and analyzed. Dynamic amplification factor (DAF) and dynamic coefficient (DC) are respectively used to evaluate the impact effect from the cable failure. Meanwhile, finite element simulations are also performed within ABAQUS. The establishments of the finished state of SFT before cable breakage and the dynamic cable failure process are presented both in the model test and FE model. Comparisons between the FE predicted values and the experimental results show a good agreement. On this basis, some influence factors are discussed in different cases of the cable-loss positions and the cable forces of ruptured cable, etc. The results show that the finished state of SFT under dead load (tube redundant buoyancy) after cable-force optimizations is more reasonable than that directly applying dead load without any cable-force adjustments, with more uniform cable force distribution and smaller tube deformation. Although the SFT suffers strong oscillations after sudden cable-breakage incident, no progressive collapse occurs when the safety margin of the rest structure is sufficient. The dynamic effect on remaining cable members due to sudden cable failure can be evaluated by DC method. A DC value of 1.5 is recommended to ensure the safety of SFT anchor-cables. When cable failure happens at the mid span of the tunnel, the deformation of SFT tube is most critical.

Abandonment and Recovery Operation of Steel Lazy-Wave Riser in Deep-water by Controlled Vessel and Cable Velocity Rate

Dynamic Analysis of Full-Circle Swinging Hoisting Operation of a Large Revolving Offshore Crane Vessel under Different Wave Directions

Dynamic Analysis of the Umbilical Cable Pull-in Operation Through J-tube under Different Wave Directions

Lifting of Horizontal Subsea Pipeline with Diverse Lifting Points in Waves: Hydrodynamic Analysis

Dynamic Analysis of Towed Cable with Variable Length During Turning Maneuvers

Dynamic Analysis of Pipeline Lifting Operations for Different Current Velocities and Wave Heights

Numerical Simulation on Dynamic Behaviour of Deepwater J-lay Systems

Numerical analysis of configuration for steel lazy-wave riser in deepwater

Numerical solutions for nonlinear large deformation behaviour of deepwater steel lazy-wave riser

Steel Lazy Wave Riser Tests in Harsh Offshore Environment

Dynamic Response Analysis for Submerged Floating Tunnel with Anchor-Cables Subjected to Sudden Cable Breakage

Dynamic Response Analysis of Towed Cable During Deployment/retrieval

Integrated Numerical Investigation of a 15 MW Semi-Submersible Wind Turbine at Moderate Water Depth

Dynamic response of steel lazy wave riser considering the excitation of internal solitary wave and ocean currents

Static Analysis of Deepwater Lazy-Wave Umbilical on Elastic Seabed

A Review on the Recent Process of Lazy Wave Risers

Sensitivity Analysis of Fatigue Life Prediction for Deepwater Steel Lazy Wave Catenary Risers

Dynamic Analysis of Marine alongside Replenishment for Highline Cable System

Mechanical Behaviors and Experimental Study of Submerged Floating Tunnel Subjected to Local Anchor-Cable Failure

Experimental and Numerical Study of Steel Lazy Wave Riser Response in Extreme Environment

A Generic Study on Lowering Analysis of Massive Jumper Structures