Abstract:The vertical foliage profile (VFP) and leaf area index (LAI) are critical descriptors in terrestrial ecosystem modeling. Although light detection and ranging (lidar) observations have been proven to have potential for deriving the VFP and LAI, existing methods depend only on the received waveform information and are sensitive to additional input parameters, such as the ratio of canopy to ground reflectance. In this study, we proposed a new method for retrieving forest VFP and LAI from Ice, Cloud and land Elevation Satellite (ICESat) Geoscience Laser Altimeter System (GLAS) data over two sites similar in their biophysical parameters. Our method utilized the information from not only the interaction between the laser and the forest but also the sensor configuration, which brought the benefit that our method was free from an empirical input parameter. Specifically, we first derived the transmitted energy profile (TEP) through the lidar 1-D radiative transfer model. Then, the obtained TEP was utilized to calculate the vertical gap distribution. Finally, the vertical gap distribution was taken as input to derive the VFP based on the Beer–Lambert law, and the LAI was calculated by integrating the VFP. Extensive validations of our method were carried out based on the discrete anisotropic radiative transfer (DART) simulation data, ground-based measurements, and the Moderate Resolution Imaging Spectroradiometer (MODIS) LAI product. The validation based on the DART simulation data showed that our method could effectively characterize the VFP and LAI under various canopy architecture scenarios, including homogeneous turbid and discrete individual-tree scenes. The ground-based validation also proved the feasibility of our method: the VFP retrieved from the GLAS data showed a similar trend with the foliage distribution density in the GLAS footprints; the GLAS LAI had a high correlation with the field measurements, with a determination coefficient (R2) of 0.79, root mean square error (RMSE) of 0.49, and bias of 0.17. Once the outliers caused by low data quality and large slope were identified and removed, the accuracy was further improved, with R2 = 0.85, RMSE = 0.35, and bias = 0.10. However, the MODIS LAI product did not present a good relationship with the GLAS LAI. Relative to the GLAS LAI, the MODIS LAI showed an overestimation in the low and middle ranges of the LAI and a saturation at high values of approximately LAI = 5.5. Overall, this method has the potential to produce continental- and global-scale VFP and LAI datasets from the spaceborne lidar system.

Quantifying the Plant Area Index of Overstory and Understory Vegetation on Sloped Terrain Using Single-Station Terrestrial Laser Scanner

Assimilating Leaf Area Index of Three Typical Types of Subtropical Forest in China from MODIS Time Series Data Based on the Integrated Ensemble Kalman Filter and PROSAIL Model

Characterizing the Three-Dimensional Spatiotemporal Variation of Forest Photosynthetically Active Radiation Using Terrestrial Laser Scanning Data

Improving UAV-Based LAI Estimation for Forests Over Complex Terrain by Reducing Topographic Effects on Multispectral Reflectance

Bottom-Up Estimation of Stand Leaf Area Index From Individual Tree Measurement Using Terrestrial Laser Scanning Data

Influence of Topography on UAV LiDAR-Based LAI Estimation in Subtropical Mountainous Secondary Broadleaf Forests

Quantifying understory vegetation density using multi-temporal Sentinel-2 and GEDI LiDAR data

Retrieving Forest Canopy Clumping Index Using Terrestrial Laser Scanning Data

Intercomparison of leaf area index observed by destructive sampling, plant canopy analyzer and tracing radiation and architecture of canopies in paddy fields

Co-inversion of island leaf area index combination morphological and spectral parameters based on UAV multi-source remote sensing data

An Automated Pipeline for Extracting Forest Structural Parameters by Integrating UAV and Ground-Based LiDAR Point Clouds

High Spatial Resolution Leaf Area Index Estimation for Woodland in Saihanba Forestry Center, China

Mapping Vegetation Heights in China Using Slope Correction Icesat Data, Srtm, Modis-Derived and Climate Data

Characterizing the Spatial Variations of Forest Sunlit and Shaded Components Using Discrete Aerial Lidar

Retrieving the Leaf Area Index of Individual Trees and Stands Using Single-Scan Data from a Terrestrial Laser Scanner.

Synchronous estimation of DTM and fractional vegetation cover in forested area from airborne LIDAR height and intensity data

Three-dimensional estimation of deciduous forest canopy structure and leaf area using multi-directional, leaf-on and leaf-off airborne lidar data

Hybrid inversion of radiative transfer models based on topographically corrected Landsat surface reflectance improves leaf area index and aboveground biomass retrievals of grassland on the hilly Loess Plateau

Integrative plant area index retrieval and spatiotemporal analysis in Taihu Lake Basin via synergistic active-passive remote sensing techniques

Retrieval of Vertical Foliage Profile and Leaf Area Index Using Transmitted Energy Information Derived from ICESat GLAS Data

Modelling Three-Dimensional Spatiotemporal Distributions of Forest Photosynthetically Active Radiation Using UAV-Based Lidar Data