Abstract:We demonstrate a low-power (Pdc) 25.5–30.7 GHz CMOS variable-gain amplifier (VGA). The VGA constitutes a common-source (CS) input stage (M1), followed by current-reused CS gain (M2) and output stages (M3). Transistors M1-M3 adopt the topology of B-to-D with RB, i.e., body terminal is connected to drain via a large resistance RB, for body self-forward-bias and floating (BSFBF). This leads to gain boosting and NF reduction of the VGA at the same Pdc due to larger transconductance gm (because of larger bias current) and smaller bias voltage, and effective suppression of the substrate leakage and noise. Simultaneous input and noise matching are achieved by suitable selection of the size and bias of M1, and the inductance of Lg1 and L1. Analog switch transistor M4 is in parallel with M3 to tune its overdrive (VOV) and drain-source voltage (VDS) for fine tuning of S21. Digital switch transistor M5 (in conjunction with the series coupling capacitance CC and resonant inductance L10) is in parallel with M2 to control its AC VDS for coarse tuning of S21. In the case of M5 being turned-on, the series of CC-M5-L10 is close to a short-circuit (~ 4.6 Ω) at the output node of M2 over the 3-dB gain bandwidth (f3dB) of 18.4–30.7 GHz. This leads to S21 tuning range boosting. Moreover, M4-M5 adopt DTMOS with RB, i.e., body of M4-M5 is connected to gate via RB, for BSFBF to lower the on-state channel resistance (Rch) and increase the off-state Rch. Further S21 tuning range boosting is attained. The VGA consumes 9 mW, and achieves S21 of 15.4 ± 1.5 dB for 18.4–30.7 GHz, tuning range of 29.8 dB (15.5 ~ − 14.3 dB) at 28 GHz, average NF (NFavg) of 2.79 dB for 18–31 GHz, and figure-of-merit (FOM) of 2.24 GHz. The NFavg and FOM are one of the best results ever reported for wideband VGAs/LNAs with Pdc lower than 10 mW. The eminent results of the VGA indicate it is suitable for 28 GHz 5G systems.

A Millimeter-Wave Variable-Gain Power Amplifier With P1 dB Improvement Technique in 65-nm CMOS

A 68.5~90 GHz High-Gain Power Amplifier with Capacitive Stability Enhancement Technique in 0.13 Μm SiGe BiCMOS

A W-band current combined power amplifier with 14.8dBm Psat and 9.4% maximum PAE in 65nm CMOS

A 60-GHz power amplifier with efficiency enhancement at power back-off

A 100–117 GHz W-Band CMOS Power Amplifier With On-Chip Adaptive Biasing

A 30Mhz-3Ghz 1W Stacked-Fet GaAs MMIC Power Amplifier.

A 24-Ghz Voltage-Combined Stacked Power Amplifier with Current-Sharing Technique in 65-Nm CMOS

A 4 W K-Band Gaas Mmic Power Amplifier With 22 Db Gain

A Compact Multilayer-Stacked Guanella Transformer Based 50–680-Mhz GaAs Power Amplifier

32.4 A 67.8-to-108.2ghz Power Amplifier with a Three-Coupled-Line-Based Complementary-Gain-Boosting Technique Achieving 442ghz GBW and 23.1% Peak PAE

A 22.8 GHz to 32.8 GHz Compact Power Amplifier with a 15 Dbm Output P1dB and 36.5% Peak PAE in 65-Nm CMOS.

A 39 GHz Doherty-Like Power Amplifier With 22dBm Output Power and 21% Power-Added Efficiency at 6dB Power Back-Off

A 1V 32.1 dBm 92-to-102GHz Power Amplifier with a Scalable 128-to-1 Power Combiner Achieving 15% Peak PAE in a 65nm Bulk CMOS Process.

A Compact E-Band Power Amplifier with Gain-Boosting and Efficiency Enhancement

A 130–150 GHz Power Amplifier for Millimeter Wave Imaging in 65-Nm CMOS

A millimeter-wave broadband power amplifier with a tree-like transistor structure using 0.15-& mu;m GaAs technology

Design and Analysis of 9-mW 25.5–30.7-GHz CMOS Variable-Gain Amplifier Using Body-Floating Gain-and-Noise-Enhancement Technique

A Compact 140-Ghz CMOS Power Amplifier with 10.5-Dbm Output Power and 27.6-Db Power Gain Supporting Up to 128-QAM Modulation

A millimeter‐wave broadband power amplifier with a tree‐like transistor structure using 0.15‐μm GaAs technology

A 68–79 GHZ 15.6DBM Power Amplifier in 65NM CMOS

Gain and Power Enhancement With Coupled Technique for a Distributed Power Amplifier in 0.25- μm GaN HEMT Technology