Co-combustion of furfural residue waste and oil shale: characteristics, synergistic effects, kinetics, and optimization analysis

Xu, Guiying,Chen, Binglun
DOI: https://doi.org/10.1007/s13399-023-04037-8
IF: 4.05
2023-03-21
Biomass Conversion and Biorefinery
Abstract:The co-combustion characteristics of furfural residue (FR) and oil shale (OS) were investigated in a thermogravimetric analyzer under different heating rate (10, 30, 50 °C/min) and mixing ratio (1:0; 3:1; 1:1; 1:3; 0:1). The effects of synergy was estimated by using the interaction coefficient, and the kinetics were looked at using the Coats-Redfern method in the co-combustion of furfural residue (FR) and oil shale (OS). To obtain the maximum the flammability index ( C ) and comprehensive combustion characteristic index (CCI), and minimum activation energy (E m ), the response surface method (RSM) was employed to find the best mixing ratio and heating rate. The ignition temperature (T1) and burnout temperature (T2) went down as the FR mixing ratio went up, but the fuel's highest burning rate ( R max ), the average burn rate (Ra), C, and CCI of mixed samples went up as the FR mixing ratio went up. The sample's T1, T2, R max , Ra, C, and CCI all went up as the heating rate went up. As the rate of heating went up, E of combustion went down. E of mixed fuel combustion was lower than E of FR combustion alone, which showed that there were interactions in the mixed combustion. The effects of this synergy were clearer when the temperature was higher. According to the model optimization, the optimal conditions were obtained.
energy & fuels,engineering, chemical
What problem does this paper attempt to address?