Abstract:Currently, relatively large errors are found in numerical results in some low-specific-speed centrifugal pumps with unshrouded impeller because the effect of clearances and holes are not accurately modeled. Establishing an accurate analytical model to improve performance prediction accuracy is therefore necessary. In this paper, a three-dimensional numerical simulation is conducted to predict the performance of a low-specific-speed centrifugal pump, and the modeling, numerical scheme, and turbulent selection methods are discussed. The pump performance is tested in a model pump test bench, and flow rate, head, power and efficiency of the pump are obtained. The effect of taking into consideration the back-out vane passage, clearance, and balance holes is analyzed by comparing it with experimental results, and the performance prediction methods are validated by experiments. The analysis results show that the pump performance can be accurately predicted by the improved method. Ignoring the back-out vane passage in the calculation model of unshrouded impeller is found to generate better numerical results. Further, the calculation model with the clearances and balance holes can obviously enhance the numerical accuracy. The application of disconnect interface can reduce meshing difficulty but increase the calculation error at the off-design operating point at the same time. Compared with the standard k-ɛ, renormalization group k-ɛ, and Spalart-Allmars models, the Realizable k-ɛ model demonstrates the fastest convergent speed and the highest precision for the unshrouded impeller flow simulation. The proposed modeling and numerical simulation methods can improve the performance prediction accuracy of the low-specific-speed centrifugal pumps, and the modeling method is especially suitable for the centrifugal pump with unshrouded impeller.

CFD analysis and prediction of centrifugal pump cavitation performance based on three-dimensional two-phase flow between impeller and worm gear

Performance Prediction of Centrifugal Pump Based on the Method of Numerical Simulation

Analysis of flow characteristics in the volute casing of centrifugal pump based on numerical simulation

Effect of Relative Positions between Blade and Volute Tongue on Prediction of Performance in Simulation of Centrifugal Pump

Numerical Simulation of Cavitating Flow in Water Hydraulic Axial Piston Pump

Numerical Simulation of the Cavitation Characteristics of A Mixed-Flow Pump

Numerical Prediction of Performance Drop Due to Cavitation in a Centrifugal Pump

Numerical Simulation and Analysis of Cavitation Flows in a Double Suction Centrifugal Pump

Analysis of Cavitation Behaviour in A Centrifugal Pump

Liquid-vapor two-phase flow in centrifugal pump: Cavitation, mass transfer, and impeller structure optimization

Numerical Simulation on Internal Flow in the Screw Centrifugal Pulp Pump

Cavitation Performance Improvement of High Specific Speed Mixed-Flow Pump

Numerical investigation of cavitating flows in bulb tubular pump and its performance prediction

Numerical Research on the Cavitation Characteristics for Typical Conditions of A Centrifugal Pump with Whole Flow Passage

Comparison of Cavitation Prediction for a Centrifugal Pump with or Without Volute Casing

Study of the Cavitation Phenomenon Inside Roller Vane Pump

Numerical Simulation of Inner Flow in Equal-pitch Inducer

Research on Improving Cavitation Performance and Based on CFD of Centrifugal Pump

CFD analysis of the air-water bubbly flow in a multiphase rotordynamic pump impeller

Hydraulic Optimization and Loss Analyses of a Low Specific-Speed Centrifugal Pump with Variable-Thickness Blades

Investigation of CFD Calculation Method of a Centrifugal Pump with Unshrouded Impeller