Abstract:This study conducts a comparative analysis, using non-equilibrium Green's functions (NEGF), of two state-of-the-art two-well (TW) Terahertz Quantum Cascade Lasers (THz QCLs) supporting clean 3-level systems. The devices have nearly identical parameters and the NEGF calculations with an abrupt-interface roughness height of 0.12 nm predict a maximum operating temperature (Tmax) of ~ 250 K for both devices. However, experimentally, one device reaches a Tmax of ~ 250 K and the other a Tmax of only ~ 134 K. Both devices were fabricated and measured under identical conditions in the same laboratory, with high quality processes as verified by reference devices. The main difference between the two devices is that they were grown in different MBE reactors. Our NEGF-based analysis considered all parameters related to MBE growth, including the maximum estimated variation in aluminum content, growth rate, doping density, background doping, and abrupt-interface roughness height. From our NEGF calculations it is evident that the sole parameter to which a drastic drop in Tmax could be attributed is the abrupt-interface roughness height. We can also learn from the simulations that both devices exhibit high-quality interfaces, with one having an abrupt-interface roughness height of approximately an atomic layer and the other approximately a monolayer. However, these small differences in interface sharpness are the cause of the large performance discrepancy. This underscores the sensitivity of device performance to interface roughness and emphasizes its strategic role in achieving higher operating temperatures for THz QCLs. We suggest Atom Probe Tomography (APT) as a path to analyze and measure the (graded)-interfaces roughness (IFR) parameters for THz QCLs, and subsequently as a design tool for higher performance THz QCLs, as was done for mid-IR QCLs. Our study not only addresses challenges faced by other groups in reproducing the record Tmax of ~ 250 K and ~ 261 K but also proposes a systematic pathway for further improving the temperature performance of THz QCLs beyond the state-of-the-art.

Real-Time Measure of the Lattice Temperature of a Semiconductor Heterostructure Laser via an On-Chip Integrated Graphene Thermometer

Real-time milli-Kelvin thermometry in a semiconductor qubit architecture

Tunable temperature sensor based on an integrated plasmonic grating

Time-Resolved Structural Measurement of Thermal Resistance across a Buried Semiconductor Heterostructure Interface

Graphene Quantum Dots as Intracellular Imaging-Based Temperature Sensors

Exploring the effects of molecular beam epitaxy growth characteristics on the temperature performance of state-of-the-art terahertz quantum cascade lasers

Measurement of cryoelectronics heating using a local quantum dot thermometer in silicon

Simulation Of Thermal Tuning In V-Coupled Cavity Laser With An On-Chip Thin-Film Heater

Thermally Tuned V-Cavity Tunable Laser with On-Chip Thin-Film Heater

Terahertz Frequency Combs Exploiting an On-Chip, Solution-Processed, Graphene-Quantum Cascade Laser Coupled-Cavity

Laser induced graphene based high-accurate temperature sensor with thermal meta-shell encirclement

A microscale nanosecond time-resolved platinum thermometer probing Gaussian pulsed laser induced temperature

Electronic thermal transport measurement in low-dimensional materials with graphene non-local noise thermometry

Anomalous Temperature Effect in Weakly Coupled Superlattices: Carrier Transport in a THz Quantum Cascade Laser

Precise nanoscale temperature mapping in operational microelectronic devices by use of a phase change material

Micro/nanoscale spatial resolution temperature probing for the interfacial thermal characterization of epitaxial graphene on 4H-SiC

Turn-key compact high temperature terahertz quantum cascade lasers: imaging and room temperature detection

Graphene-Based Transparent Flexible Heat Conductor For Thermally Tuning Nanophotonic Integrated Devices

High dynamic range, heterogeneous, terahertz quantum cascade lasers featuring thermally-tunable frequency comb operation over a broad current range

Photonic and Thermal Modelling of Microrings in Silicon, Diamond and GaN for Temperature Sensing

Single-Material Graphene Thermocouples