Abstract:Background/Objectives: Nowadays, demand for power converters in high-voltage applications such as wind power, electric locomotives, BESS, and HVDC has increased rapidly. However, high-voltage applications have great problems in the limited ability of power electronic devices. Because of this reason, numerous studies have been conducted to find solutions that can increase the operating voltage of new semiconductor power switching devices. Methods/Statistical analysis: In this paper, we propose a circuit configuration for a high-voltage-isolated DC–DC converter. Since the operating voltage range of the switching device is limited, research on a DC–DC configuration operating at a high voltage has hardly been conducted. The proposed configuration of converter is divided into two parts: the high-voltage side consists of a serial modular multilevel converter (MMC) and the other is a low voltage, rectifier diode bridge, both connected to a high-frequency transformer. Findings: A novel configuration of a DC–DC converter that can be applied to high voltage is mentioned. This is largely divided into two sides, consisting of a high-voltage MMC, a low-voltage H-bridge rectifier, and a high-frequency transformer connecting the two sides. The circuit configuration will be presented and verified by modeling and experimental results that can determine the practicality of the new phase with pulse width modulation (PWM). Improvements/Applications: The proposed converter is suitable for high-voltage applications with high step ratio and insulation characteristics between the source and load. A PWM-based phase shift algorithm is provided to control the output voltage. The cell rotation selection is applied to achieve the self-balancing capacitor voltage level.

Three-Level DC-DC Boost Converter for Wind Energy Conversion

A High Efficiency High Power Step-Up Resonant Switched-Capacitor Converter for Offshore Wind Energy Systems

Analysis and Comparison of Medium Voltage High Power DC/DC Converters for Offshore Wind Energy Systems

Applying Diode-Capacitor Voltage Multiplier to Coupled-Inductor Boost Converter for Novel DC-DC Converter with High Voltage Gain and Low Voltage Stress

A Three-Phase Interleaved Floating Output Boost Converter

Control Strategy of Cascaded Multilevel Converter Based on Dual Active Bridge for Wind Energy Conversion System.

A Self-Balancing Non-isolated DC/DC Converter for DC Wind Power Conversion System

A Component-Minimized Dual-Output Multilevel Converter and Its Applications

Improved Topology and Control Strategies for DC Converters in Wind Power Full DC Systems

A High Step-up DC-DC Converter with Three-winding Coupled Inductor for Sustainable Energy Systems

The Modular Multilevel Converter for High Step-Up Ratio DC–DC Conversion

High Ratio DC/DC Converter for Offshore Wind Farms with MVDC Collection System

DC–DC Converter with High Conversion Ratio for Transmission

A High-Power Step-Up DC/DC Converter Dedicated to DC Offshore Wind Farms

Design and Analysis of Novel High-Gain Boost Converter for Renewable Energy Systems (RES)

A High Conversion Ratio and High-Efficiency Bidirectional DC–DC Converter With Reduced Voltage Stress

Design and development of a new three‐phase AC‐DC single‐stage wind energy conversion system

Novel High Step-Up DC–DC Converter with Three-Winding-Coupled-Inductors and Its Derivatives for a Distributed Generation System

Design of a Modular, High Step-Up Ratio DC–DC Converter for HVDC Applications Integrating Offshore Wind Power

PWM Plus Phase-Shift Controlled DC-DC Converter for Use in Series-Connected DC Wind Farm

Power Electronics Converters for Wind Turbine Systems