Abstract:A novel, simple and efficient method by the combination of hydroxyl radicals and electrical exfoliation of graphite for the green production of high-quality graphene from graphite was first developed in our self-manufactured exfoliation apparatus. In this work, we focused on the investigation of the roles of various electrolyte systems for the exfoliation of graphite. Sodium chloride, sodium hydroxide, poly vinyl pyrrolidone (PVP), dodecyl trimethyl ammonium bromide (DTAB) and sodium dodecyl benzene sulfonate (SDBS) were tested as the electrolyte. The yields of the graphene product in sodium hydroxide, PVP, DTAB, sodium chloride and SDBS electrolyte system were 32.9%, 34.0%, 45.2%, 77.5% and 83.5%, respectively. The experimental result demonstrated that graphite can be successfully exfoliated to graphene in these electrolytes, with SDBS showing the best exfoliation effect. We further investigated the effects of process parameters on the graphite exfoliation in the SDBS system by single factor experiments. The obtained optimal process parameters were as follows: graphite dosage, 5.0 g; SDBS solution concentration, 10.0% (w/v); applied current strength, 10 mA; air flow, 1.0 L h-1; and exfoliation time, 3 h. At these conditions, the yield of the graphene product was 89.7%. TEM results revealed that the graphene product possessed the characteristic features of a thin-layer graphene sheet. XRD results showed that the graphene products still maintained the structures of carbon atoms or molecules. FT-IR and Raman results indicated that the products exhibited the characteristic peaks and the absorption peaks of graphene. AFM test results revealed that the layer number of graphene product obtained was about 2, while the layer numbers of the graphene products obtained from sodium hydroxide, PVP, DTAB and sodium chloride systems were 30, 20, 4 and 3, respectively, at the same experimental conditions. The observed exfoliation effect in the SDBS system was due to its good electrical conductivity, which was favorable for the formation of hydroxyl radicals in exfoliation. Furthermore, SDBS has good hydrophilic properties and can enable even dispersion of graphite in the system. These two effects facilitated the exfoliation of graphite to form good-quality graphene. SDBS as the electrolyte did not corrode the electrode, and it could be recycled; also, it does not pollute the environment and reduces the production cost, which is favorable for mass production.

Scalable preparation of high-quality graphene by electrochemical exfoliation: effect of hydrogen peroxide addition

Electrochemically derived functionalized graphene for bulk production of hydrogen peroxide

A Novel and Efficient Approach to Prepare Few-Layer Graphene with High Quality

Graphene: Simultaneous Electrochemical Dual‐Electrode Exfoliation of Graphite Toward Scalable Production of High‐Quality Graphene (adv. Funct. Mater. 37/2019)

Electrolyte engineering for the mass exfoliation of graphene oxide across wide oxidation degrees

Ultrahigh yield of hydrogen peroxide on graphite felt cathode modified with electrochemically exfoliated graphene

Synthesis of High-Quality Graphene through Electrochemical Exfoliation of Graphite in Alkaline Electrolyte

Efficient Exfoliation of Graphite in Chloroform with a Pyrene-Containing Hyperbranched Polyethylene As Stabilizer to Render Pyrene-Functionalized High-Quality Graphene

Highly efficient dual-electrode exfoliation of graphite into high-quality graphene via square-wave alternating currents

Synthesis of high-quality graphene by electrochemical anodic and cathodic co-exfoliation method

Highly Efficient Preparation of Graphite Oxide without Water Enhanced Oxidation

Effects of different electrolytes on the structure and yield ofgraphene oxide produced via electrochemical exfoliation

Green and facile production of high-quality graphene from graphite by the combination of hydroxyl radicals and electrical exfoliation in different electrolyte systems

Electrochemical exfoliation of graphite in H<sub>2</sub>SO<sub>4</sub>, Li<sub>2</sub>SO<sub>4</sub> and NaClO<sub>4</sub> solutions monitored <i>in situ</i> by Raman microscopy and spectroscopy

Scalable production of electrochemically exfoliated graphene by an extensible electrochemical reactor with encapsulated anode and dual cathodes

High-Yield, Large-Scale Production of Few-Layer Graphene Flakes Within Seconds: Using Chlorosulfonic Acid and H2o2 As Exfoliating Agents

Exfoliation and Dispersion of Graphene in Ethanol-Water Mixtures

SYNTHESIS OF GRAPHENE OXIDE USING MILDLY OXIDIZED GRAPHITE THROUGH ULTRASONIC EXFOLIATION

Synthesis of Graphene Sheets with High Electrical Conductivity and Good Thermal Stability by Hydrogen Arc Discharge Exfoliation.

Mechanochemical Preparation of Edge-Selectively justify Hydroxylated Graphene Nanosheets Using Persulfate via a Sulfate Radical-Mediated Process

Oxidative Modification of Graphite Felts for Efficient H2O2 Electrogeneration: Enhancement Mechanism and Long-Term Stability