Abstract:This paper presents four new designs for a first-order voltage-mode (VM) all-pass filter (APF) circuit based on two single-output positive differential voltage current conveyors (DVCCs). The first two proposed VMAPFs with unity-gain, high-input (HI) impedance and low-output (LO) impedance use two DVCCs, a grounded capacitor, and a grounded resistor. The last two proposed first-order VMAPFs with HI impedance and variable-gain control are two resistors added to each of the first two VMAPFs. The last two proposed first-order VMAPFs with variable-gain control use two DVCCs, one grounded capacitor, and three grounded resistors and provide HI impedances, so that VMAPFs can be directly cascaded to obtain high-order filters without additional voltage buffers. The four implementation circuits based only on grounded passive components are particularly applicable for integrated circuits (ICs). To confirm the cascading characteristics, an application example of a fully-uncoupled quadrature sinusoidal oscillator (FQSO) is also proposed. PSpice simulation results have confirmed the feasibility of the proposed structures. VMAPF and FQSO circuits are also constructed from commercial AD8130 and AD844 ICs, and their experimentally measured time and frequency responses are compared to theoretical values. The supply voltages for both the AD8130 and AD844 ICs were ± 5 V. The measured power dissipation of the proposed first-order VMAPF and second-order FQSO circuits is 0.6 W. The measured input 1-dB compression point for the four VMAPFs is about 19 dB. The measured total harmonic distortion of the four VMAPFs is less than 0.67% when the input voltage reaches 2.5 Vpp. The calculated figures of merit for the four VMAPFs are 628.2 × 103, 603.06 × 103, 516.53 × 103, and 496.42 × 103, respectively.

Single VDGA-Based Mixed-Mode Electronically Tunable First-Order Universal Filter

The voltage-mode first order universal filter using single voltage differencing differential input buffered amplifier with electronic controllability

Resistorless First-Order Universal Filter Structures Employing OTAs with Independent Controllability of Gain and Pole Frequency

0.3-V Voltage-Mode Versatile First-Order Analog Filter Using Multiple-Input DDTAs

Current-Mode First-Order Versatile Filter Using Translinear Current Conveyors with Controlled Current Gain

Low-Voltage Mixed-Mode Analog Filter Using Multiple-Input Multiple-Output Operational Transconductance Amplifiers

Voltage-Mode Multifunction and Universal Biquads with Two CFOAs

A triple-mode ring dielectric resonator band-pass filter using substrate integrated waveguide (SIW)

A Miniaturized Dual‐mode Zeroth‐order Ring Bandpass Filter with One Left‐handed Unit and a Capacitive Stub

Reconfigurable Microwave Photonic Transversal Filter Using a Variable Gain Tilt Filter

Synthesis of electronically tunable multifunction biquad filter using voltage differencing differential input buffered amplifiers

Four Unity/Variable Gain First-Order Cascaded Voltage-Mode All-Pass Filters and Their Fully Uncoupled Quadrature Sinusoidal Oscillator Applications

Current-Mode Active Filter Using EX-CCCII

CNTFET Based Fully Differential First Order All Pass Filter

Design and Verification of a New Universal Active Filter Based on the Current Feedback Operational Amplifier and Commercial AD844 Integrated Circuit

Minimum Component Based First-Order Inverting and Non-inverting Outputs of All-Pass Filter at the Same Circuit

Bandwidth and Center Wavelength Tunable Micro-Ring Optical Filter with Vernier Effect by Four Spectrum Combination

Novel Single-Ended-to-Balanced Filter With Reconfigurable Working Modes, Frequency, Bandwidth, and Single/Dual-Band Operations

A Dual-Mode Monoblock Dielectric Bandpass Filter Using Dissimilar Fundamental Modes

Tunable Multi-Tap Microwave Photonic Filter With Complex Coefficients Using A Dual-Parallel Mach-Zehnder Modulator

Current feedback operational amplifier‐based fully orthogonal universal and multifunction filters