Abstract:This study is a report on successful synthesis of strontium titanate (SrTiO3) nanocubes using a conventional hydrothermal method, their assembly on mesoporous graphitic carbon nitride (mpg-C3N4) to yield novel SrTiO3/mpg-C3N4 nanocomposites, as well as sonocatalyst performance of SrTiO3/mpg-C3N4 to eliminate basic violet 10 (BV10) as a model pollutant from aqueous solutions. To this end, the structure of as-synthesized SrTiO3/mpg-C3N4 nanocomposites was characterized through TEM, HR-SEM, EDS, XRD, FTIR, BET, PL, and UV–vis DRS analyses. To manifest the sonocatalytic performance of SrTiO3/mpg-C3N4 nanocomposites, the main operating parameters such as sonocatalyst dosage, solute concentration, ultrasonic power, initial pH, and reaction time span for the elimination of BV10 were also examined. The best sonocatalytic performance of 80% was further achieved using 0.3 g L−1 sonocatalyst, 10 mg L−1 BV10, and an ultrasonic power of 240 W at pH = 5 (natural) in 120 min of reaction time. The removal rate constant of BV10 via US/SrTiO3/mpg-C3N4 system was 0.0146 min−1, almost 12 times higher than that achieved by the only ultrasonic process. According to these results, the kinetics of dye elimination system could be determined by the use of pseudo-first-order kinetic model and scavenging compounds also exerted the following adverse effects on the sonocatalytic efficiency in the order of EDTA-2Na 3/mpg-C3N4 nanocomposites under the sonocatalytic system. Finally, a reusability test of SrTiO3/mpg-C3N4 nanocomposites in the BV10 removal revealed that nearly 10% drop had been observed after the five successive cycles.

Influence of synthesis procedures on the preparation of strontium titanate nanoparticles and photocatalytic application for methylene blue degradation

Synthesis and high photocatalytic hydrogen production of SrTiO3 nanoparticles from water splitting under UV irradiation

Influence of Preparation Method on Morphology and Photocatalysis Activity of Nanostructured TiO2.

Synthesis of Nano-Sized SrTiO3 Photocatalyst by Sol-Gel Method

EG-solvothermal Synthesis of Self-Assembly SrTiO3 Nano Sheets and Photocatalytic Property

Strontium and manganese co-doped TiO2 nanoparticles for the enhanced photocatalytic degradation of methylene blue dye

Synthesis Of Nano-Porous Strontium Titanate Materials for Photocatalysis

Pva-Assisted Hydrothermal Synthesis Of Srtio3 Nanoparticles With Enhanced Photocatalytic Activity For Degradation Of Rhb

A new approach to optimize the synthesis parameters of TiO2 microsphere and development of photocatalytic performance

Strontium-induced phase, energy band and microstructure regulating in Ba1-xSrxTiO3 photocatalysts for boosting visible-light photocatalytic activity

Synthesis, Characterization and Photocatalytic Activity of Hierarchical Spherical TiO2 Nanostructures

Photocatalytic degradation of selected dyes by titania thin films with various nanostructures

Controlled solvothermal synthesis of self-assembled SrTiO3 microstructures for expeditious solar-driven photocatalysis dye effluents degradation

Strontium titanate nanocubes assembled on mesoporous graphitic carbon nitride (SrTiO3/mpg-C3N4): Preparation, characterization and catalytic performance

Enhanced Photocatalytic Performance of SrTiO3 Powder Induced by Europium Dopants

Exploring the Role of Titanate Perovskites in the Oxidation of Amines via Photocatalysis

Exploring the Role of Titanate Perovskites in the Oxidation of Amines to Imines via Photocatalysis

Bismuth and chromium co-doped strontium titanates and their photocatalytic properties under visible light irradiation

Synthesis, Structure, and Energetic Characteristics of Perovskite Photocatalyst SrTiO3: an Experimental and DFT Study

Visible Light-Driven Photocatalysis of Al-Doped SrTiO3: Experimental and DFT Study

Preparation of mesoporous strontium carbonate nanospheres with the enhanced photoactivity for TC degradation under visible light