Abstract:Biomass-derived fast pyrolysis liquid, also called bio-oil (FPBO), can replace petroleum fuels in thermal devices, but several undesirable properties hinder its widespread application. This paper aims to improve these properties and quantify their effect on its combustion performance. In this study, higher quality bio-oil having similar viscosity and surface tension as FPBO was obtained through the thermo-catalytic reforming bio-oil (TCRBO) process. The effect of fuel chemical composition, thermogravimetric analysis (TGA) residue, fuel volatility, heating value, water content, solid content, and ash content was examined in a 10 kW spray burner. Gas phase emissions and particulate matter (PM) were also measured and compared to its operation on fuel oil #2 for which diesel was used. TCRBO ignited irrespective of the primary air preheat temperature, and its evaporation characteristics (i.e., TGA residue of less than 3%) were more like diesel. TCRBO does not display any flash atomization. Both FPBO and TCRBO displayed coking potential; however, for TCRBO, no coking was observed if the primary air was heated above 110 °C. FPBO droplets were larger in size (∼100 μm) and could not achieve complete burnout due to increasing emissions. TCRBO exhibits lower emissions than FPBO at any given operating point, primarily due to better atomization achieved due to its higher fuel heating value, which reduced the fuel flow rate by almost 40%. FPBO resulted in the highest PM emissions, which can be attributed to the formation of secondary char particles. Higher fuel ash content also contributed to the PM emissions. The reduction in fuel water content (i.e., ∼2 wt %) made the TCRBO flame less susceptible to blow out, and a stable flame was observed without the pilot flame. Swirl and pilot were necessary to stabilize the FPBO flame. The TCRBO's higher fuel nitrogen content significantly increased its NOx emissions. Overall, thermo-catalytic reforming significantly improved the combustion characteristics of pyrolysis bio-oil. Although TCRBO was obtained from lower quality feedstock (e.g., sewage sludge), its superior combustion performance is attributed to the ability of the TCR process to produce higher quality liquid fuels from various biomass sources.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acs.energyfuels.1c04129.List of acronyms, schematic of the experimental setup, description of equipment, and main chemical constituents of FPBO/TCRBO (PDF)This article has not yet been cited by other publications.

Statistical analysis of the uniformity of sprays of tire pyrolysis oil-diesel oil blends

Atomization Characteristics of Pyrolysis Oil Derived from Waste Tires

Combustion Characteristics of Aromatic-Enriched Oil Droplets Produced by Pyrolyzing Unrecyclable Waste Tire Rubber

Fuel and Chemical Properties of Waste Tire Pyrolysis Oil Derived from a Continuous Twin-Auger Reactor

On the distillation of waste tire pyrolysis oil: A structural characterization of the derived fractions

AN EXPERIMENTAL STUDY ON EFFERVESCENT ATOMIZATION OF BIO-OIL FUELS

The Role of Atomization in the Spray Combustion of a Fast Pyrolysis Bio-Oil

Assessing the usage of end-of-life tire pyrolysis oil as an alternative fuel in a diesel engine in the point of energy, exergy, exergoeconomic, exergoenviroeconomic, and sustainability parameters

Spray Flame Characteristics of Bio-Derived Fuels in a Simulated Gas Turbine Burner

Assessment of performance and emission characteristics of CI engine using tyre pyrolysis oil and biodiesel blends by nano additives: An experimental study

Performance of Tire Pyrolytic Oil and its Blends with Biodiesel in Diesel Engine

Carbonyl emission and toxicity profile of diesel blends with an animal-fat biodiesel and a tire pyrolysis liquid fuel

On Fractioning the Tire Pyrolysis Oil in a Pilot-Scale Distillation Plant under Industrially Relevant Conditions

Experiment and analysis on the spray characteristics of diesel/polyoxymethylene dimethyl ethers (PODE)/ethanol blends in non-reacting environment

Recycle process and industrial use of pyrolytic oil from waste tire pyrolysis

Effect of fuel modification and after treatment techniques on emissions fuelled by diesel tyre oil blend

Role of injection pressure on fuel atomization and spray penetration on the Thevetia peruviana and Jatropha curcas biodiesel blends with nanoparticle

Performance, Combustion, and Emission analysis of diesel engine fuelled with pyrolysis oil blends and n-propyl alcohol-RSM optimization and ML modelling

Pyrolysis Oils from Used Tires and Plastic Waste: A Comparison of a Co-Processing with Atmospheric Gas Oil

Polyoxometalate Catalyzed Oxidative Desulfurization of Diesel Range Distillates from Waste Tire Pyrolysis Oil

Advancing the Application of Pyrolysis Liquid (Bio-oil) by the Improvement of Its Fuel Properties by Thermo-Catalytic Reforming