Abstract:Thermochemical conversion of biomass has been studied extensively over the last decades. For the design, optimization and modeling of thermochemical conversion processes, such as fixed bed pyrolysis, a sound understanding of pyrolysis is essential. However, the decomposition mechanism of most biomass types into gaseous, liquid, and solid fractions is still unknown because of the complexity of pyrolysis and differences in biomass composition.The aim of this study was to find characteristic differences in the pyrolysis behavior of three widely used biomass feedstocks to optimize the performance of industrial fixed bed pyrolysis. This aim was achieved in three steps. First, devolatilization kinetics during pyrolysis of three biomass types was investigated in a thermogravimetric analyzer (TGA). Then, a one-step multi-component pyrolysis model with three independent parallel reactions for hemicellulose, cellulose and lignin was derived to correlate the kinetics with single component decomposition and to identify their amount in the biomass sample. In a final step, the findings were tested in a fixed bed reactor at laboratory scale to prove applicability in industrial processes.Three types of biomass were chosen for this investigation: wheat straw, rape straw and spruce wood with bark. They represent biomass with a high cellulose, hemicellulose and lignin content, respectively. Since lignin is the most stable and complex of these three biomass components, its amount is assumed to be the main controlling factor in the thermochemical decomposition process.The thermogravimetric (TG) curve of spruce wood with bark was found to shift to about 20K higher temperatures compared to the TG curves of straw and rape straw. This result indicates that a higher activation energy is needed to decompose woody biomass, which contains a higher amount and a different type of lignin than straw. Three wood decomposition phases were distinguished from the negative first derivatives curves (DTG): a shoulder during hemicellulose decomposition, a peak during cellulose decomposition and a smaller rise during lignin decomposition. By comparison both herbaceous biomass types decomposed in only two phases at lower temperatures. The decomposition of the herbaceous, and woody biomass samples was completed at about 830K and 900K, respectively, leaving only a solid residue of ash. The derived pyrolysis model estimated the composition and described the devolatilization curves of each biomass with sufficient accuracy for industrial processes, although the same activation energy set, taken from the literature, was used for each biomass. In the fixed bed pyrolysis experiments similar characteristics were found to those in the TGA experiments. Herbaceous biomass with a higher cellulose and hemicellulose content decomposed faster and produced a larger fraction of gaseous products than woody biomass with a higher lignin content. According to the assessment of the product distribution, performed after each experiment, woody biomass pyrolysis led to a larger fraction of solid products than herbaceous biomass pyrolysis. We conclude that industrial fixed bed pyrolysis can be optimized for different biomass feedstocks with a specific composition of cellulose, hemicellulose and lignin.

Thermal Decomposition and Kinetic Parameters of Three Biomass Feedstocks for the Performance of the Gasification Process Using a Thermogravimetric Analyzer

Thermodynamic Analysis of Fischer-Tropsch Fuels from Biomass

Influence of Torrefaction on Biomass Gasification Performance in A High-Temperature Entrained-Flow Reactor

Pyrolysis of lignocellulosic, algal, plastic, and other biomass wastes for biofuel production and circular bioeconomy: A review of thermogravimetric analysis (TGA) approach

TGA and macro-TGA characterisation of biomass fuels and fuel mixtures

Comparison of Gasification Performances Between Raw and Torrefied Biomasses in an Air-Blown Fluidized-Bed Gasifier

Kinetic Analysis on Non-isothermal Combustion of Several Urban Biomass Fuels

Artificial neural network-assisted thermogravimetric analysis of thermal degradation in combustion reactions: A study across diverse organic samples

Combustion Characteristics and Kinetic Analysis of Biomass Pellet Fuel Using Thermogravimetric Analysis

Nonisothermal Thermogravimetric Kinetic Investigations On Combustion Behaviors Of Concomitant Biomass From Urban Plants

Thermal and kinetic analyzing of pyrolysis and combustion of self-heating biomass particles

Kinetic and quantitative analysis of gaseous products of thermochemical biomass conversion based on thermogravimetric and mass‐spectrometric data

Thermal analysis technology to utilize waste biomass and waste heat to produce high-quality combustible gas through simulations and experiments

Evaluation of Kinetic and Thermodynamic Parameters of Pyrolysis and Combustion Processes for Bamboo Using Thermogravimetric Analysis

TGA and kinetic study of different torrefaction conditions of wood biomass under air and oxy-fuel combustion atmospheres

Quantitative and Kinetic TG-FTIR Investigation on Three Kinds of Biomass Pyrolysis

The effect of the biomass components lignin, cellulose and hemicellulose on TGA and fixed bed pyrolysis

TGA Pyrolysis and Gasification of Combustible Municipal Solid Waste

Characterization of Reactivity Enhancement Coal Combustion with Empty Fruit Bunches Using Thermogravimetry Analysis

Thermogravimetric Characteristics and Non-isothermal Kinetics of Macro-Algae With an Emphasis on the Possible Partial Gasification at Higher Temperatures