Abstract:Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, Ahead of Print. To enhance the vibratory roller's comfort, three different types of seat suspension including the seat's semi-active suspension system (SASS) controlled by the FLC-PID controller, seat's passive suspension system (PSS) added by the quasi-zero stiffness structure (QZSS), and seat's SASS added by the QZSS are proposed. Three different vehicle dynamic models including a one-dimensional (1D) model, two-dimensional (2D) model, and three-dimensional (3D) model are established to evaluate the performance and stability of the seat's suspension systems under different operating conditions. The root mean square (RMS) acceleration and power spectral density (PSD) acceleration of the seat have been selected as the evaluation indexes. The mathematical model and numerical simulation method are then tested via the experiment to enhance the reliability of the research results. The research result shows that the seat's vibration characteristic using 1D, 2D, and 3D models is the same. However, the seat's RMS acceleration and maximum PSD acceleration using the 1D model are increased by 30.6% and 61.7% in comparison with the 3D model, whereas the seat's acceleration and PSD acceleration using the 3D model are like the measured results. Thus, the use of the vehicle model greatly influences the research result. By adding the QZSS into the seat's SASS, the seat's RMS and maximum PSD accelerations are greatly reduced in comparison with all seat's PSS, seat's SASS without the QZSS, and seat's PSS added by QZSS. Therefore, the seat's SASS added by the QZSS should be applied to further enhance the vibratory roller's comfort.

Enhancing the vibratory roller's ride comfort with semi-active seat suspension embedded by quasi-zero stiffness structure

Adaptive control of a vehicle-seat-human coupled model using quasi-zero-stiffness vibration isolator as seat suspension

Performance study of semi-active seat suspension added by quasi-zero stiffness structure under various vibratory roller models

Enhancing the ride comfort of off-road vibratory rollers with seat suspension using optimal quasi-zero stiffness

Vibration analysis and optimization of QZSS's parameters added to the vehicle's seat suspension

Isolation Efficiency of Vehicle Seat Suspension with Three Quasi-Zero Stiffness Models

A novel semi-active control of an integrated chassis and seat quasi-zero stiffness suspension system for off-road vehicles

Semi-Active Vibration Control of Seat Suspension Equipped with a Variable Equivalent Inertance-Variable Damping Device

Effect of delayed resonator on the vibration reduction performance of vehicle active seat suspension

Ride comfort investigation of semi-active seat suspension integrated with quarter car model

Investigation of a seat suspension installed with compact variable stiffness and damping rotary magnetorheological dampers

Prescribed Performance Control-Based Semi-Active Vibration Controller for Seat Suspension Equipped with an Electromagnetic Damper

Performance evaluation of a novel semi-active absorption and isolation co-control strategy with magnetorheological seat suspension for commercial vehicle

Effect of time-delay feedback control on vehicle seat vibration reduction and suspension performance

Research on Vibration Reduction Performance of Electromagnetic Active Seat Suspension Based on Sliding Mode Control

Semi-Active Suspension Control Strategy Based on Negative Stiffness Characteristics

Improvement in Ride Comfort and Vehicle Stability using Hybrid Semi-Active Suspension System

Improving ride comfort and road friendliness of heavy truck using semi-active suspension system

Design and verification of a seat suspension with variable stiffness and damping

Ride Comfort Analysis on Vehicle Using a New Nonlinear Isolator for the Seat Suspension

Ride comfort analysis of vehicle seat suspension systems: A co-simulation study