Numerical simulation of flow-induced vibration of the one-degree-of-freedom circular cylinder using random vortex-boundary element method at turbulent flow

Saeed Jamshidi,Amin Haghighi Poshtiri,Mohammad Ebrahim Maali
DOI: https://doi.org/10.1007/s40430-023-04037-9
IF: 2.361
2023-02-04
Journal of the Brazilian Society of Mechanical Sciences and Engineering
Abstract:In this study, the turbulent flow around a circular cylinder in stationary and oscillating states has been simulated two-dimensionally using a Random Vortex-Boundary element method. The results were obtained in the Reynolds number of and the mass and damping ratio of 11 and 0.001, respectively. Also, the reduced velocity is considered to be in the range of 4–14. Comparing the numerical results with the experimental results showed a 1.81% error in the Random vortex-Boundary element method at a Reynolds number of . Moreover, this method predicted the flow pattern with higher accuracy compared to the DES turbulence model. Comparing the present results with the results of the DES turbulence model showed that the computational time of the present method is considerably lower than the DES method. Unlike other methods, this method shows the temporal variations in the drag and lift coefficient values in a turbulent flow. Also, it was found that the cylinder displacement amplitude is large in the lock-in region such as , and the flow pattern shows the 2P mode. Furthermore, the cylinder displacement range is very limited beyond this region, such as , and the flow pattern shows the 2S mode similar to the flow around the stationary cylinder.
engineering, mechanical
What problem does this paper attempt to address?