Abstract:A new jet fuel surrogate was developed in this work by emulating real jet fuel properties including physical, gas phase chemical properties and threshold sooting index (TSI). An intelligent optimization methodology was proposed to calculate the species composition that inherently satisfies both the physical and chemical characteristics as well as sooting tendency. Eight properties were selected as the target properties for the jet fuel surrogate development, including liquid density, viscosity, surface tension, cetane number (CN), hydrogen carbon (H/C) ratio, molecular weight (MW), lower heating value (LHV) and TSI. As a result, the CN, H/C ratio, LHV, TSI and density of the new jet fuel surrogate are reproduced excellently with very little deviations within 3%. The averaged deviation of viscosity is −6.318% and the deviations of MW is 9.776%. As the highest deviation among all properties, the averaged deviation of surface tension is 11.76%. Based on the newly developed jet fuel surrogate, a skeletal jet fuel surrogate mechanism with 5 components including decalin, n-dodecane, iso-cetane, iso-octane and toluene was developed. The skeletal jet fuel surrogate mechanism was significantly compacted into 74 species and 189 reactions by describing the chemistries for the oxidation of large molecules C4–Cn and small H2/CO/C1 molecules respectively, which makes it practical to be used for 3-D engine combustion simulations. The validations of ignition delay times present reasonable agreement between experiment and predictions over a wide range of equivalence ratios (0.5–2.0) and pressures (8–30 atm), except for a shift of negative temperature coefficient (NTC) region towards higher temperatures at Φ = 1.5, 20 atm: in the simulation the NTC region is from 830 K to 950 K while in the experiment the NTC region is from 740 K to 890 K. The predicted species concentrations can reproduce the trend of the experimental data, especially for O2, CO and CO2. The simulated laminar flame speed at 400 K and 470 K are with absolute averaged deviations of 3.5% and 4.06% respectively. The constant volume spray and combustion validations are reasonably good. In the engine combustion validations, a multistep soot model was embedded into the new jet fuel surrogate mechanism. The predicted in-cylinder pressure can reproduce the experimental data, expect for small deviations after the peak pressure (the averaged deviation is around 6.2% after the peak pressure). The embedded soot model can well reproduce the trend of the experimental data. It can be concluded that this new jet fuel surrogate mechanism is compact and robust for the utilization in diesel engine combustion simulation.

Heteroatomic jet fuel components: Lichen substances as fuel component and potential additives

Continuous Hydrodeoxygenation of Lignin to Jet-Range Aromatic Hydrocarbons

A comprehensive review of the thermal oxidation stability of jet fuels

Alternative Aviation Fuels Evaluated for Lean-Flame NOx and Blowout, and Rich-Flame Soot Threshold

Development of a New Jet Fuel Surrogate and Its Associated Reaction Mechanism Coupled with a Multistep Soot Model for Diesel Engine Combustion

Ignition Delay Time and Oxidation of a Kerosene Aviation Fuel and a Blended Jet50-Bio50 Fuel

Fundamental study of jet fuel oxidative deposit formation

Solvent-free dehydration, cyclization, and hydrogenation of linalool with a dual heterogeneous catalyst system to generate a high-performance sustainable aviation fuel

Jet fuel containing ligand-protecting energetic nanoparticles: A case study of boron in JP-10

Three-Dimensional Fluorescence Spectra of Thermally Stressed Commercial Jet A-1 Aviation Fuel in the Autoxidative Regime

Strategical Design of Bridged Vanillic Schiff-bases As Jet Fuel Antioxidants

Shock Tube Measurements of Species Time-Histories during Jet Fuel Pyrolysis and Oxidation

Low-temperature Thermal Oxidation of Biomass Jet Fuel Pinane

Conversion of bio-jet fuel from palm kernel oil and its blending effect with jet A-1 fuel

Formulation of 7-Component Surrogate Mixtures for Military Jet Fuel and Testing in Diesel Engine

A study of the sooting behavior of hydro-processed renewable jet and petroleum jet fuels in a laminar counter-flow flame

Physicochemical properties of exhaust soot from lower and higher alcohols: Characterizations and impact on soot oxidation behavior

A merged kinetic mechanism study of two aviation surrogate fuels

Soot Morphology and Nanostructure Differences between Chinese Aviation Kerosene and Algae-Based Aviation Biofuel in Free Jet Laminar Diffusion Flames

Highly Selective Upgrading of Biomass-Derived Alcohol Mixtures for Jet/Diesel-Fuel Components.

Effects of adding n-amyl alcohol, dimethylfuran to fuel on soot formation in aviation kerosene diffusion flame