Abstract:This paper deals with the initial shape analysis, cutting-pattern analysis, surface accuracy measurement and modal testing of high-precision inflatable antennas reflectors that are intended for spaceflight applications. The initial shape analysis method, formulated on the basis of membrane theory and elastic mechanics, determines the required as-manufactured shape of the reflective surface of the antenna reflector. On the other hand, the cutting-pattern analysis method, with its formulation based on spring-mass representations, numerically calculates the required cutting pattern of the planar membrane gores that are to be assembled to form the 3-dimensional reflective surface. To validate the effectiveness of the proposed analysis methods, a 3.2-m antenna reflector model was designed, manufactured, and assembled for ground demonstration and testing. The reflective surface accuracy of this demonstration reflector model was measured by a photogrammetric measuring system. Shape adjustments of the reflective surface were performed by systematically adjusting the tension in the cables that were used to mount the reflector to its support structure. It was found that the reflective surface accuracy of the reflector model, as defined by its RMS error from a best-fit parabolic shape, was less than 1mm. In addition, dynamic and RF tests were also performed on the demonstration reflector model. The test results indicated that the first-mode frequency of the reflector model agreed well with the corresponding analytical prediction, and its radiation pattern was also well focused.

Structural Design and Analysis of an Airborne Equipment

Structural design and mechanical analysis for space-borne electronic equipment

Thermal Design For High Density Avionics Package

Mechanical Simulation Analysis of Aerospace High Reliability Electronic Equipment

Structural Design of a High Heat Consumption at Airborne Electronic Equipment

Structure design and mechanical measurement of inflatable antenna

Deployable Tetrahedral Truss Antenna Initial Structural Design Based on Interpretative Structural Model Analysis

Research on Maintenance Method of Typical Aircraft Electronic Equipment Based on Thermal Analysis Technology

Modularization and Parametric Design of Airborne Electronic Equipment Structure

Thermal Design and Structure Optimization of a Signal Controlling and Processing Equipment

Reliability Analysis for Structure of Airborne Air Conditioner

Tolerance Modeling and Analysis Considering Form Defects for Spaceborne Array Antenna

Numerical simulation and experiment for thermal behavior of stratospheric electronic equipment

Thermal-Structure Coupling Analysis of Microgravity Environment Simulation Suspension Structure for Large Space Deployable Mechanisms

Thermal Analysis and Design of Electronic Equipments

Thermal Vibration Analysis of the Antenna of Low Orbit Satellites of the Earth

Equipment/System Safety Design Process in Civil Aircraft Considering Structure-Support Requirements

Ultrasonic Guided Wave Health Monitoring of High-Temperature Aircraft Structures Based on Variational Mode Decomposition and Fuzzy Entropy

OPTIMIZING DESIGN METHOD FOR CHASSIS STRUCTURE OF ELECTRONIC EQUIPMENT BASED ON MECHANICAL, ELECTRIC AND THERMAL THREE-FIELD COUPLING

Design and Simulation Analysis of Deployable Structure of a Single-unit Radar

Temperature Distribution in a Long-Span Aircraft Hangar