Abstract:Shock-induced plastic deformation and spall damage in the single-crystalline FCC Co25Ni25Fe25Al7.5Cu17.5 high-entropy alloy (HEA) under varying shock intensities were systematically investigated using large-scale molecular dynamics simulations. The study reveals the significant influence of crystalline orientation on the deformation mechanism and spall damage. Specifically, the shock wave velocities in the [110] and [111] directions are significantly higher than that in the [001] direction, resulting in a two-zone elastic-plastic shock wave structure observed in the [110] and [111] samples, while only a single-wave structure is found in the [001] sample. The plastic deformation is dominated by the FCC to BCC transformation following the Bain path and a small amount of stacking faults during the compression stage in the [001] sample, whereas it depends on the stacking faults induced by Shockley dislocation motion in the [110] and [111] samples. The stacking faults and phase transformation in the [001] sample exhibit high reversibility under release effects, while extensive dislocations are present in the [110] and [111] samples after release. Interestingly, tension-strain-induced FCC to BCC phase transformation is observed in the [001] sample during the release stage, resulting in increased spall strength compared to the [110] and [111] samples. The spall strength estimated from both bulk and free surface velocity history shows reasonable consistency. Additionally, the spall strength remains stable with increasing shock intensities. The study discusses in detail the shock wave propagation, microstructure change, and spall damage evolution. Overall, our comprehensive studies provide deep insights into the deformation and fracture mechanisms of Co25Ni25Fe25Al7.5Cu17.5 HEA under shock loading, contributing to a better understanding of dynamic deformation under extreme environments.

Adiabatic shear localization induced by dynamic recrystallization in an FCC high entropy alloy

Microstructural evolution in adiabatic shear localization in Al0.4CoCrFeNi high-entropy alloy

Abnormal hardening and amorphization in an FCC high entropy alloy under extreme uniaxial tension

Adiabatic Shear Localization in Nanostructured Face Centered Cubic Metals under Uniaxial Compression

High-velocity deformation of Al0.3CoCrFeNi high-entropy alloy: Remarkable resistance to shear failure

Effect of High Strain Rate on Adiabatic Shear Susceptibility and Microstructures in Al0.4CoCrFeNi High-Entropy Alloy

Unraveling Anisotropy in Crystalline Orientation under Shock-Induced Dynamic Responses in High-Entropy Alloy Co25Ni25Fe25Al7.5Cu17.5

Unusual phase transformation and novel hardening mechanisms upon impact loading in a medium entropy alloy with dual heterogeneous structure

Dynamic impact behavior and deformation mechanisms of Cr26Mn20Fe20Co20Ni14 high-entropy alloy

Experimental and numerical study on the dynamic shear banding mechanism of HfNbZrTi high entropy alloy

Dynamic shear behavior of forged CrMnFeCoNi high entropy alloy using hat-shaped specimens over a wide range of temperatures and strain rates

Molecular simulation of microstructure evolution and plastic deformation of nanocrystalline CoCrFeMnNi high-entropy alloy under tension and compression

Semi-solid thixotropic behavior and microstructure evolution of cold deformed CoCrCu 1.2 FeNi high-entropy alloy

Microstructure and Mechanical Properties of Face‐Centered‐Cubic‐Based Cr‐Free Equiatomic High‐Entropy Alloys

Characteristic deformation microstructure evolution and deformation mechanisms in face-centered cubic high/medium entropy alloys

Dynamic mechanical properties and microstructure evolution of AlCoCrFeNi2.1 eutectic high-entropy alloy at different temperatures

Chemical short-range ordering accompanies shear band initiation in CrCoNi medium entropy alloy

Investigations on the role of chemical short-range order in the tensile deformation of FCC Co30Fe16.67Ni36.67Ti16.67 high-entropy alloys via Monte Carlo and molecular dynamics hybrid simulations

Temperature-dependent dynamic compressive properties and failure mechanisms of the additively manufactured CoCrFeMnNi high entropy alloy

The Exceptional Strong Face-centered Cubic Phase and Semi-coherent Phase Boundary in a Eutectic Dual-phase High Entropy Alloy AlCoCrFeNi

Microstructural Characteristics and Formation Mechanism of Adiabatic Shear Bands in Al–Zn–Mg–Cu Alloy under Dynamic Shear Loading