Abstract:The contamination of water resources by emerging contaminants, such as heavy metals and textile effluents, poses significant ecological and human health risks. Conventional effluent treatment plants may not effectively degrade all types of pollutants, resulting in the contamination of natural water resources. Photocatalysis, specifically the photo-Fenton reaction, has emerged as an efficient sustainable cost-effective method for the removal of pollutants. In this study, three batches (CF-1, CF-2, and CF-3) of copper ferrite nanoparticles (NPs) were synthesized and used as photocatalysts for the degradation of methylene blue (MB) dye and reduction of hexavalent chromium (Cr(VI)) under visible light. The CF-1, CF-2, and CF-3 required (90, 75, and 60 min.) different periods to reach a nearly similar degradation percentage, i.e., 90%, wherein the CF-3 batch demonstrated better catalytic activity. The successful synthesis of copper ferrite NPs was confirmed by XRD analysis which reveals the CuFe 2 O 4 phase. With the increased concentration of copper, the formation of the CuO phase alongside the CuFe 2 O 4 phase was observed. The CF-3 catalyst had a surface area of 44.496 m 2 /g according to BET studies. The catalyst exhibited a pore radius of 19.175 Å and an adsorption pore volume of 0.109 cc/g, as determined by the BJH method. TEM micrographs showed spherical-shaped NPs with sizes ranging from 55 to 60 nm. The photo-Fenton process was optimized by varying dye concentration, pH, catalyst, and hydrogen peroxide (H 2 O 2 ) dosages for MB degradation. The scavenger study reveals the contribution of the •OH radical over •O 2 − radical in the photo-Fenton process for MB degradation. The reduction of Cr(VI) was optimized by adjusting pH and Cr load. The CF-3 catalyst exhibited almost complete degradation of MB (32 mg/L) within 60 min and reduction of Cr(VI) (100 mg/L) within 20 min. The good reusability of the catalyst exhibits 71.4% MB degradation after four cycles and 78.34% Cr(VI) reduction after five cycles. The regression coefficient ( R 2 ) of the pseudo-second-order reaction was close to 1 and higher than the pseudo-first-order reaction. The catalyst achieved 0.0540 and 0.1047 1/min kinetic constant at pseudo-first-order reaction, while 0.0614 and 0.0497 L/mg.min kinetic constant was achieved at pseudo-second-order reaction for MB degradation and Cr(VI) reduction. These kinetic studies proved that the dye degradation and chromium reduction follow the pseudo-second-order reaction ( R 2 ). The overall study demonstrates the promising potential of magnetic CF-3 nanoparticles as efficient catalysts for industrial applications in dye degradation and Cr(VI) reduction.

Exploring Cu-doped graphitic carbon nitride for treatment of dye pollutants in textile wastewater: Benefits and limitations

Efficient photocatalytic degradation of textile dye pollutants using thermally exfoliated graphitic carbon nitride (TE–g–C3N4)

Accelerated Decoloration of Organic Dyes from Wastewater Using Ternary Metal/g-C3N4/ZnO Nanocomposites: An Investigation of Impact of g-C3N4 Concentration and Ni and Mn Doping

Effective mitigation of single-component and mixed textile dyes from aqueous media using recyclable graphene-based nanocomposite

Enhanced simultaneous degradation of simulated dyes using ZnO/GCN heterojunction photocatalyst

Use of biogenic copper nanoparticles synthesized from a native Escherichia sp. as photocatalysts for azo dye degradation and treatment of textile effluents.

Carbon/Mn3O4/SrTiO3 Microsphere Photocatalyst for the Efficient Removal of High-Concentration Methylene Blue from Water

Simultaneous photocatalytic removal of organic dye and heavy metal from textile wastewater over N-doped TiO2 on reduced graphene oxide

Green synthesis of biomass-derived carbon quantum dots for photocatalytic degradation of methylene blue

Enhanced degradation of dyes using a novel CuS/g-C 3 N 4 /rGO ternary composite catalyst: Synthesis, characterization, and mechanistic insights

Catalytic Oxidation of Dyeing Wastewater by Copper Oxide Activating Persulfate: Performance, Mechanism and Application

Hollow Polyaniline Microsphere/MnO2/Fe3O4 Nanocomposites in Adsorptive Removal of Toxic Dyes from Contaminated Water

TiO2-Based Heterostructure Containing g-C3N4 for an Effective Photocatalytic Treatment of a Textile Dye

Rationally tailored synergy between adsorption efficiency of cotton shell activated carbon and PMS activation via biogenic Fe 0 or Cu 0 for effective mitigation of triphenylmethane dyes

Efficient photocatalysis of Cu doped TiO2/g-C3N4 for the photodegradation of methylene blue

Catalytic and kinetic studies of CuFe2O4 as a superior heterogeneous nanocatalyst for dye degradation and Cr(VI) reduction

Capability of copper–nickel ferrite nanoparticles loaded onto multi-walled carbon nanotubes to degrade acid blue 113 dye in the sonophotocatalytic treatment process

Effective removal of methylene blue dye from water with nanocomposite ceramsites in a fixed-bed column

Bifunctional Copper Modified Graphitic Carbon Nitride Catalysts for Efficient Tetracycline Removal: Synergy of Adsorption and Photocatalytic Degradation

g-C3N4/CuO loaded polyester fabric as effective Fenton-like dip-catalyst for the oxidation of dyes

Copper(II)-Doped Carbon Dots as Catalyst for Ozone Degradation of Textile Dyes