Abstract:Carbon fibers (CFs) have been widely used as reinforcing materials because of their excellent specific strength, specific modulus, corrosion resistance, energy absorption, and other properties. To improve the mechanical properties of CF-reinforced composites, one of the effective methods is to improve the interfacial force between the CF and the polymer through modification of CFs. The aim of this study is to modify the surface of the CF with an environmentally friendly and efficient way and to design a continuous production equipment. In this research, a continuous electro-polymerization equipment was designed, and the surface of the CFs was modified by epoxy or vinyl ether, which was initiated by photoinitiator UVI-6974 without adding any solvent and extra electrolytes. By changing the structure of monomers, polymerization time, voltage, concentration of the initiator, and the distance between CFs and electrodes, the performance and thickness of the polymer layer on the CFs were controllable. The results of scanning electron microscopy and infrared spectroscopy proved that the surface of the CFs was covered by polymers, and some unreacted functional groups remained. The mechanical performances of CF composites prepared from the BDE/DVE-3-modified CFs showed that the interlaminar shear strength improved by 46.98 and 62.02%, and the tensile strength improved by 11.40 and 16.62%, respectively, compared with unmodified CFs. This proved that the interface force between the resin and the CF was greatly improved by the thin polymer layer on the surface of the CF and the unreacted functional groups. On the other hand, if pigments or dyes were added to the polymerization system, colored CFs could be fabricated by this equipment continuously. Because of the solvent-free, low-voltage, and continuous fabrication, this electro-polymerization method has a good industrial prospect.This article has not yet been cited by other publications.

Surface modification of carbon-fiber-reinforced plastic by using photo-activated chlorine dioxide radicals as pretreatment of electroless plating

Research on Surface Treatment of Carbon Fiber and the Conductive Properties of Paper

Enhancing CFRP Laminates with Plasma Jet Arrays: A Study of Interlaminar Mechanical Properties

Polymer Surface Oxidation by Light-Activated Chlorine Dioxide Radical for Metal–Plastics Adhesion

Effects of carbon fibers modification on the properties of unsaturated polyester self-healing composites

Effect of Electrochemical Aryl Diazonium Salt Modification on Interfacial Properties of CF/PEEK Composites

Improved Amine Functionalization of Carbon Fiber Surfaces by O2 Plasma Activation Treatment

Study on new process of electroless copper plating pretreatment on carbon fiber surface

Surface modification of carbon fibers by anodic oxidation

Surface Modification of Carbon Fiber by Electro-Polymerization: Continuous Production, Thickness Control, Colorization, and Preparation of CFRP

Surface coarsening of carbon fiber/cyanate ester composite for adhesion improvement of electroless copper plating as conductive patterns

Effect of Electrochemical Oxidation on the Surface Structure and Mechanical Performance of High Strength and High Modulus Carbon Fibers

Effect of electrochemical anodic oxidation modification on the interfacial properties of carbon fiber reinforced polyimide composites

Influence of Fibre Surface Oxidation–reduction Followed by Silsesquioxane Coating Treatment on Interfacial Mechanical Properties of Carbon Fibre/polyarylacetylene Composites

A Study on the Surface Oxidation Pretreatment and Nickel Plating Mechanism of Carbon Fiber

Electroless plating of copper on carbon fiber surfaces and corresponding mechanism

Study on Carbon Fiber Surface Treatment Based on Surface Oxidation Method

Carbon Fiber Surface Modification by Plasma Treatment for Interface Adhesion Improvements of Aerospace Composites

Effect of surface functionalization on the surface and inter-facial properties of thermoplastic-coated carbon fibers

The Effect of Oxidation Treatment by KClO3/H2SO4 System on Intersurface Performance of Carbon Fibers

Study on Technique of Pretreatment for Electroless Nickel Plating on Carbon Fiber