Abstract:Large-scale experiments were conducted in an above-ground gallery to simulate typical fires that develop along conveyor belt transport systems within underground coal mines. In the experiments, electrical strip heaters, imbedded ~5 cm below the top surface of a large mass of coal rubble, were used to ignite the coal, producing an open flame. The flaming coal mass subsequently ignited 1.83-meter-wide conveyor belts located approximately 0.30 m above the coal surface. Gas samples were drawn through an averaging probe located approximately 20 m downstream of the coal for continuous measurement of CO, CO2, and O2 as the fire progressed through the stages of smoldering coal, flaming coal, and flaming conveyor belt. Also located approximately 20 m from the fire origin and approximately 0.5 m below the roof of the gallery were two commercially available smoke detectors, a light obscuration meter, and a sampling probe for measurement of total mass concentration of smoke particles. Located upstream of the fire origin and also along the wall of the gallery at approximately 14 m and 5 m upstream were two video cameras capable of both smoke and flame detection. During the experiments, alarm times of the smoke detectors and video cameras were measured while the smoke obscuration and total smoke mass were continually measured. Twelve large-scale experiments were conducted using three different types of fire-resistant conveyor belts and four air velocities for each belt. The air velocities spanned the range from 1.0 m/s to 6.9 m/s. The results of these experiments are compared to previous large-scale results obtained using a smaller fire gallery and much narrower (1.07-m) conveyor belts to determine if the fire detection criteria previously developed (1) remained valid for the wider conveyor belts. Although some differences between these and the previous experiments did occur, the results, in general, compare very favorably. Differences are duly noted and their impact on fire detection discussed.

Use of coupled TG-FTIR and Py-GC/MS to study combustion characteristics of conveyor belts in coal mines

Pyrolysis characteristics and dynamics analysis of a coal mine roadway conveyor belt

Hazard analysis of flue gases generate by coal mining conveyor belt fires

Investigation of a conveyor belt fire in an underground coal mine: Experimental studies and CFD analysis

Experimental research on combustion property of mine fire source

Evaluation of Criteria for the Detection of Fires in Underground Conveyor Belt Haulageways

Co-combustion of Coal and Carbonaceous Wastes: Thermogravimetric Analysis

Chemical compounds released by combustion of polymer composites flat belts

Mine conveyor belt fire classification

Lessons Learned from Fires of the Wood Caused by the Spontaneous Combustion of Coal Dust in Underground Mines

Characteristics of mass, heat and gaseous products during coal spontaneous combustion using TG/DSC–FTIR technology

Thermogravimetric analysis of the co-combustion of the blends with high ash coal and waste tyres

The Toxicological Testing and Thermal Decomposition of Drive and Transport Belts Made of Thermoplastic Multilayer Polymer Materials

Study on Pyrolysis and Oxidation Characteristics of Coal Gangue Based on TGA-DSC

Influence of High Sulfate Mine Water on Spontaneous Combustion of Coal

Analysis of the Behaviour of Pollutant Gas Emissions During Wheat Straw/coal Cofiring by TG–FTIR

A Fully Coupled Hydro-Thermo-mechanical Model for the Spontaneous Combustion of Underground Coal Seams

Investigation of Thermal Behavior and Hazards Quantification in Spontaneous Combustion Fires of Coal and Coal Gangue

Spontaneous combustion of coal in regenerated roof and its prevention technology

Study on Spontaneous Combustion "Three Zones" of the Distribution Law and Integrated Fire Prevention Technology in Mined-Out Area of Lingquan Mine

Spontaneous combustion in six types of coal by using the simultaneous thermal analysis-Fourier transform infrared spectroscopy technique