Abstract:Upper limb exoskeleton rehabilitation devices can improve the quality of rehabilitation and relieve the pressure of rehabilitation medical treatment, which is a research hotspot in the field of medical robots. Aiming at the problems such as large volume, high cost, low comfort, and difficulty in promotion of traditional exoskeleton rehabilitation devices, and considering the lightweight, discontinuous, high flexibility, and high biomimetic characteristics of tensegrity structure, we designed an upper limb bionic exoskeleton rehabilitation device based on tensegrity structure. First, this article uses mapping methods to establish a mapping model for upper limb exoskeletons based on the tensegrity structure and designs the overall structure of upper limb exoskeletons based on the mapping model. Second, a bionic elbow joint device based on gear and rack was designed, and the stability of the bionic elbow joint was proved using the positive definite matrix method. This device can simulate the micro displacement between bones of the human elbow joint, improve the axial matching ability between the upper limbs and the rehabilitation device, and enhance the comfort of rehabilitation. Third, an impedance control scheme based on back propagation (BP) neural network was designed to address the low control accuracy of flexible structures and patient spasms. Finally, we designed the impedance control scheme of the PSO-BP neural network based on a fuzzy rehabilitation state evaluator. The experimental results show that the exoskeleton rehabilitation device has good flexion motion stability and assist ability and has significant advantages in volume and mobility. The control strategy proposed in this paper has high control precision and adaptive ability and has potential application value in the field of medical rehabilitation.

Bionic Design to Reduce Driving Power for a Portable Elbow Exoskeleton Based on Gravity-balancing Coupled Model

An Upper-Limb Power-Assist Exoskeleton Using Proportional Myoelectric Control

Design and Compliance Control of Rehabilitation Exoskeleton for Elbow Joint Anchylosis

Development and analysis of a gravity-balanced exoskeleton for active rehabilitation training of upper limb

Kinematics and Dynamics Analysis of a 3-DOF Upper-Limb Exoskeleton with an Internally Rotated Elbow Joint

Reducing the Human-Exoskeleton Interaction Force Using Bionic Design of Joints

Design and Evaluation of Torque Compensation Controllers for a Lower Extremity Exoskeleton

Design and Control of an Upper Limb Bionic Exoskeleton Rehabilitation Device Based on Tensegrity Structure

Evaluation of a 1-DOF Hand Exoskeleton for Neuromuscular Rehabilitation

Design and Analysis of Upper Limb Passive Exoskeleton Robot for Lift Assist

Design and analysis of a lower limb assistive exoskeleton robot

Design and Performance Analysis of a Bioelectronic Controlled Hybrid Serial-Parallel Wrist Exoskeleton

Design of a biologically inspired lower limb exoskeleton for human gait rehabilitation

Biofusion design and parameter optimization for a novel passive assisted knee exoskeleton robot based on eight-bar mechanism

Dynamic analysis and design of a multipurpose lower limb exoskeleton for rehabilitation

Concept design of hybrid-actuated lower limb exoskeleton to reduce the metabolic cost of walking with heavy loads

Structure design and analysis of upper limb wearable passive power-assisted exoskeleton robot

Design and Control of a Quasi-Direct Drive Soft Exoskeleton for Knee Injury Prevention during Squatting

Enhancing the Performance of a Biomimetic Robotic Elbow-and-Forearm System Through Bionics-Inspired Optimization

Design and analysis of a multi-motion self-balancing lower limb exoskeleton based on flat terrain