Sulfur defect and Fe(III) (hydr)oxides on pyrite surface mediate tylosin adsorption in lake water: effect of solution chemistry and dissolved organic matter

Qian Zhang,Jinwen Zhou,Lishan Zhang,Shan Zhong,Xuan Ru,Xiaohua Shu
DOI: https://doi.org/10.1007/s11356-022-22140-7
IF: 5.8
2022-07-24
Environmental Science and Pollution Research
Abstract:Pyrite affects the adsorption of tylosin (TYL) due to their coexistence in the lake system. As well as the reactivity groups of S–S-H, S-OH, and Fe-OH, defects also have the possibilities to influence the adsorption of organic contaminants. However, the role of these active sites in antibiotic adsorption on pyrite has not been deeply studied. Besides, pH, N, P, dissolved oxygen, and dissolved organic matter (DOM) fluctuate greatly in lake at different seasons, which may change the surface characteristics of pyrite. Hence, the adsorption of TYL on natural pyrite considered solution chemistry and DOM in lake water was explored in this study. The fitting results of the kinetic and isotherm models showed that the adsorption included physical and chemical interactions. The neutral initial solution pH was conductive to TYL adsorption owing to the combined result of electrostatic and cover of Fe-oxyhydroxide. NO 3 − and NH 4 + had no effect on TYL adsorption, whereas H 2 PO 4 − promoted adsorption by forming flocculent Fe(H 2 PO 4 ) 3 precipitates. The dissolved oxygen increased adsorption. This is due to the co-promotion of the pyrite oxidation by oxygen and sulfur defects. The Fe(II)-DOM complex caused by pyrite surface oxidation reduced the concentration of TYL in solution by gathering. Except for the surface charge, reactivity groups on pyrite significantly influenced the adsorption of TYL. The bond fracture of S–S resulted in sulfur defects that contributed to pyrite oxidation. As a result, Fe(III)/Fe(II) on the surface of pyrite or in solution produced a complex Fe(III)/Fe(II) with anions and DOM. In addition, Fe(III)-S on sulfur defects interacted with the O–H of TYL through hydrogen bonding. Furthermore, the Fe–O-C bond is formed by the interaction of C–OH on TYL and Fe(III) (hydr)oxides on the surface of pyrite. The study provides a deep insight into the effect of pyrite surface active sites on amphoteric antibiotic adsorption. It helps to understand antibiotic migration and interactions with widespread pyrite in the real environment.
environmental sciences
What problem does this paper attempt to address?