Abstract:The wastewater generated by the pharmaceutical industry poses a risk to the environment due to undesirable characteristics such as low biodegradability, high levels of contaminants, and the presence of suspended solids, in addition to the high load of organic matter due to the presence of drugs and other emerging products in the effluent. This study aims to reduce the impact of wastewater pollution by removing amoxicillin (AMO) antibiotics as an organic pollutant. In this concept, two synthesized catalysts, NiAl2O4 and ZnO, are sensitive oxides to light energy. The prepared materials were then characterized using X-ray diffraction, UV–vis solid reflectance diffuse, Raman spectroscopy, scanning electron microscopy, BET, and ATR-FTIR spectroscopy. The effects of principal operating parameters under sunlight, namely, the percentage of the mixture of NiAl2O4 and ZnO, the pH of the medium, and the initial concentration of the antibiotic were studied experimentally to determine the optimal conditions for achieving a high degradation rate. The results showed that photodegradation is higher at a pH of 6, with a weight percentage of the mixture of 50% for both catalysts in 1 g/L of the total catalyst dose. Then, the effect of the initial concentration of AMO on the photodegradation reaction showed an important influence on the photodegradation process; as the degradation rate decreases, the initial AMO concentration increases. A high degradation rate of 92% was obtained for an initial AMO concentration of 10 mg/L and a pH of 6. The kinetic study of degradation established that the first-order model and the Langmuir–Hinshelwood (LH) mechanism fit the experimental data perfectly. The study showed the success of using heterosystem photocatalysts and sustainable energy for effective pharmaceutical removal, which can be extended to treat wastewater with other organic emerging pollutants. On the other hand, modeling was introduced using Gaussian process regression (GPR) to predict the degradation rate of AMO under sunlight in the presence of heterogeneous ZnO and NiAl2O4 systems. The model evaluation criteria of GPR in terms of statistical coefficients and errors show very interesting results and the performance of the model used. Where statistical coefficients were close to one (R = 0.9981), statistical errors were very small (RMSE = 0.1943 and MAE = 0.0518). The results suggest that the model has a strong predictive power and can be used to optimize the process of AMO removal from wastewater.

Functionalized SnO2 nanoparticles with gallic acid via green chemical approach for enhanced photocatalytic degradation of citalopram: synthesis, characterization and application to pharmaceutical wastewater treatment

Investigation of the Aquatic Photolytic and Photocatalytic Degradation of Citalopram

Green Hydrothermal Synthesis of Zinc Oxide Nanoparticles for UV-Light-Induced Photocatalytic Degradation of Ciprofloxacin Antibiotic in an Aqueous Environment

Photocatalytic degradation of tetracycline in aqueous systems under visible light irridiation using needle-like SnO2 nanoparticles anchored on exfoliated g-C3N4

Photocatalytic Degradation of Inherent Pharmaceutical Concentration Levels in Real Hospital WWTP Effluents Using g-C3N4 Catalyst on CPC Pilot Scale Reactor

Effective photodegradation of cefixime and carvedilol mediated by visibly active MoO3/CoMn2O4/Cu2BaSnS4 photocatalytic system: An insight on photocatalytic mechanism, degradation pathway and by-product toxicity analysis

High-efficient photocatalytic degradation of commercial drugs for pharmaceutical wastewater treatment prospects: A case study of Ag/g-C3N4/ZnO nanocomposite materials

Response surface optimised photocatalytic degradation and quantitation of repurposed COVID-19 antibiotic pollutants in wastewaters; towards greenness and whiteness perspectives

Rational engineering and fabrication of efficient nanophotocatalysts based on ZnO-SrO-CdS for pharmaceutical pollutants based wastewater degradation

Fabrication of new composite NCuTiO2/CQD for photocatalytic degradation of ciprofloxacin and pharmaceutical wastewater treatment: degradation pathway, toxicity assessment

Immobilizing nanocatalyst onto polyvinyl alcohol cross-linked by sodium alginate: a new strategy to degrade high amount of chloramphenicol and amitriptyline

Preparation of Ce0.9Zr0.1O2/SnIn4S8 composite photocatalyst and its degradation of typical antibiotic pollutants

Photo-Catalytic Activity Improvement for Organic Pollutant Removal in Wastewater using Zinc Oxide Quantum Dots: An Experimental and Modeling Study

Exploring the efficiency of nitrogenated carbon quantum dots/TiO2 S-scheme heterojunction in the photodegredation of ciprofloxacin in aqueous environments

Improved Synthesis of Cu2O NPs and Ascorbic Acid-Modified Derivatives for Adsorption of Brilliant Cresyl Blue: Surface and Reusability Studies

Photocatalytic degradation of metronidazole and oxytetracycline by novel l-Arginine (C, N codoped)-TiO2/g-C3N4: RSM optimization, photodegradation mechanism, biodegradability evaluation

Clean technology and response surface approach for the photodegradation of selected antibiotics by catalyst supported on pine activated carbon

Convenient fabrication of ultrafine VOx decorated on porous g-C3N4 for boosting photocatalytic degradation of pharmaceuticals with peroxymonosulfate

Synthesis and Characterisation of Dual Z-Scheme V2O5/g-C3N4 Photocatalysts for Degrading Ciprofloxacin Antibiotics Under Visible Light

Sustainable Photodegradation of Amoxicillin in Wastewater with a Nickel Aluminate and ZnO Heterosystem Oxides: Experimental and Gaussian Process Regression Modeling Studies

Stable fabrication of S-step photocatalyst assembled from Cu-doped SnO 2 yolk-shell hollow spheres capsulated by MnCo 2 O 4 nanoparticles for enhancing antibiotic photodegradation