Abstract:Structural Health Monitoring, Ahead of Print. Ultrasonic-guided wave (UGW) is an important technology for realizing structural health monitoring (SHM), and the piezoelectric transducer (PZT) is a commonly used actuator and sensor. The PZT layer is fabricated using a flexible printed circuit (FPC), and the interface of the PZTs is connected to the host of the monitoring system via cables. The flexible PZT layer (FPL) is easy to install, highly reliable, and widely used in industrial sites. However, as the distance between the host and the FPL gradually increases, the problem of guided wave (GW) signal attenuation caused by cables cannot be ignored. In addition, the use of shielded cables has the problem of heavy quality and high cost, and the use of unshielded cables has the problem of signal interference. Therefore, this paper proposes a digital smart layer (DSL) composed of a flexible signal acquisition system and a PZT array. The DSL acquires excitation and GW signals acquisition and performs PZT diagnostics. It connects to the host via a fixed six-wire cable and uses digital signals for communication. Multiple DSLs can be interconnected to form a network and perform damage detection simultaneously, improving the monitoring area and damage detection efficiency of the system. An experimental system was constructed on an aluminum plate to verify the functionality of the DSL. The results prove that the DSL solves the problems of signal attenuation and interference susceptibility of GW signal in long-distance cable transmission and realizes the diagnosis of PZT faults such as debonding and breakage. This paper provides a highly reliable and practical means of monitoring the condition of equipment structures such as airplanes, trains, and bridges.

Design of cable pipeline fault location device based on dynamic laser scanning

A High-Precision Laser Displacement Measurement System

Design of an Autonomous and Controllable Laser Ranging System

Design and implementation of embedded signal processing system based on pulsed laser ranging technology

Obstacle Detection by ALV Using Two 2D Laser Range Finders

Design of Mobile Robot for Slotted Pipeline Detection

Robotic System with Power Line Communication for In-pipe Inspection of Underground Urban Gas Pipeline

Technology of data acquisition and flaw spotting in oil pipeline leakage detecting system

Development of a Portable High-Precision above Ground Marker System for an MFL Pipeline Inspector

Simulation of defect detection for the buried petroleum pipe by the X-ray backscatter imaging

On-line Detection of Gas Pipeline Based on the Real-Time Algorithm and Network Technology with Robot

Design of a Self-referenced Laser Scanning and Ranging System

Research on Distributed Optical Fiber Pipeline Micro Leakage Detection Technology Based on Recursive Least Square

Study on Real-Time Spatial Distance Acquisition Method of Transmission Line Based on Laser Point Cloud and Image Monitoring

Pipeline Intrusion Detection and Location Based on Phase-Sensitive Optical Time Domain Reflectometer

Design and Implementation of High Precision Online Thickness Gauge by Laser Displacement Sensor

Design and calibration of a three-dimensional localization system for automatic measurement of long and thin tube based on camera and laser displacement sensor

Design and implementation of a digital smart layer for ultrasonic-guided wave-based structural health monitoring

Redundant Manipulator Based Autonomous Scanning for Unknown Variable Cross-Section Pipe

Phase to Phase Distance Measurement Based on Terrestrial Laser Scanner

Development of new pipeline maintenance system for repairing early-built offshore oil pipelines