Abstract:The characterization and quantification of functional groups in technical lignins are among the chief obstacles of the utilization of this highly abundant biopolymer. Although several techniques were developed for this purpose, there is still a need for quick, cost-efficient, and reliable quantification methods for lignin. In this paper, three sampling techniques for fourier transform infrared (FTIR) spectroscopy were assessed both qualitatively and quantitatively, delineating how these affected the resultant spectra. The attenuated total reflectance (ATR) of neat powders and DMSO-d6 solutions, as well as transmission FTIR using the KBr pelleting method (0.5 wt%), were investigated and compared for eight lignin samples. The ATR of neat lignins provided a quick and easy method, but the signal-to-noise ratios in the afforded spectra were limited. The ATR of the DMSO-d6 solutions was highly concentration dependent, but at a 30 wt%, acceptable signal-to-noise ratios were obtained, allowing for the lignins to be studied in the dissolved state. The KBr pelleting method gave a significant improvement in the smoothness and resolution of the resultant spectra compared to the ATR techniques. Subsequently, the content of phenolic OH groups was calculated from each FTIR mode, and the best correlation was seen between the transmission mode using KBr pellets and the ATR of the neat samples (R2 = 0.9995). Using the titration measurements, the total OH and the phenolic OH group content of the lignin samples were determined as well. These results were then compared to the FTIR results, which revealed an under-estimation of the phenolic OH groups from the non-aqueous potentiometric titration, which was likely due to the differences in the pKa between the lignin and the calibration standard 4-hydroxybenzoic acid. Further, a clear correlation was found between the lower Mn and the increased phenolic OH group content via SEC analyses. The work outlined in this paper give complementary views on the characterization and quantification of technical lignin samples via FTIR.

Single-Standard Quantification Strategy for Lignin Dimers by Supercritical Fluid Chromatography with Charged Aerosol Detection

Energy-Resolved Mass Spectrometry As a Tool for Identification of Lignin Depolymerization Products.

Examining functional group-dependent effects on the ionization of lignin monomers using supercritical fluid chromatography/electrospray ionization mass spectrometry

A Complementary Multitechnique Approach to Assess the Bias in Molecular Weight Determination of Lignin by Derivatization-Free Gel Permeation Chromatography

High-performance liquid chromatography/high-resolution multiple stage tandem mass spectrometry using negative-ion-mode hydroxide-doped electrospray ionization for the characterization of lignin degradation products.

Complementarity of two-dimensional gas chromatography and two-dimensional liquid chromatography for the analysis of depolymerised lignin

Chemometric Combination of Ultrahigh Resolving Mass Spectrometry and Nuclear Magnetic Resonance Spectroscopy for a Structural Characterization of Lignin Compounds

Quantification of native lignin structural features with gel‐phase 2D‐HSQC0 reveals lignin structural changes during extraction

Advancing Molecular Weight Determination of Lignin by Multi-Angle Light Scattering

Lignin phenol quantification from machine learning‐assisted decomposition of liquid chromatography‐absorbance spectroscopy data

Lignin structure dynamics: Advanced real-time molecular sensing strategies

Oxidative Depolymerisation of Lignosulphonate Lignin into Low-Molecular-Weight Products with Cu–Mn/δ-Al2O3

The Effect of Sample Preparation Techniques on Lignin Fourier Transform Infrared Spectroscopy

Determining monolignol oxifunctionalization by direct infusion electrospray ionization tandem mass spectrometry

Study of the Reactivity of Lignin Model Compounds to Fluorobenzylation Using 13C and 19F NMR: Application to Lignin Phenolic Hydroxyl Group Quantification by 19F NMR

Application of Generalized Standard Addition Method and Ultraviolet Spectroscopy to Quantify Electrolytic Depolymerization of Lignin

Anisole-based assessment for the quantification of methoxyl groups in lignin-rich biomass

Guidelines for Identifying the Structure of Heavy Phenolics in Lignin Depolymerization by Using High‐Resolution Tandem Mass Spectrometry

A facile spectroscopic method for measuring lignin content in lignocellulosic biomass

[Determination of main degradation products of lignin using reversed-phase high performance liquid chromatography].

New Insights Toward Quantitative Relationships between Lignin Reactivity to Monomers and Their Structural Characteristics