Abstract:Mil-101 (Cr) material is considered to be one of the most potential thermochemical energy storage materials in recent years. It has the advantages of a typical S-type water adsorption isotherm. Has low working temperature and large water adsorption amount. However, the adsorption properties of the material need to be improved under low water pressure. To improve the performance, the acidified MWCNTs were added before the hydrothermal reaction of mil-101 (Cr) materials to optimize the micropore structure. After the preparation, the new composite thermochemical energy storage materials were prepared by impregnation with a certain concentration of calcium chloride aqueous solution. The effects of multi-walled carbon nanotubes and calcium chloride on the physical and chemical properties of the materials were discussed. Through X-ray diffraction experiment, scanning electron microscope, microstructure analysis, nitrogen adsorption capacity test, water adsorption capacity test, and other means, the micro characteristics, pore structure, crystal morphology, and chemical composition of the materials were characterized, and the water adsorption performance of the materials was synthesized. The experimental results show that the addition of carbon nanotubes can improve the pore properties of the materials so that the porous organic skeleton can accommodate more calcium chloride particles. The composite materials with calcium chloride can provide excellent hydrophilicity and high water adsorption capacity. Also, the water absorption rate and adsorption-desorption cycle capacity of the material have been significantly improved. The experimental results show that when the mass fraction of calcium chloride reaches 30% when 90 mg acidified MWCNTs are added into every four chromium nitrate crystals, the hydrophilicity and adsorption capacity of the composite can reach a high equilibrium state. At the same time, the experimental yield of the material is high, the product is easy to obtain, the environmental friendliness is also reflected, so it is expected to become the adsorption heat pump thermochemical energy storage material with research potential.

Improved Adsorption Cooling Performance of MIL-101(Cr)/GO Composites by Tuning Water Adsorption Rate

Enhanced Water Adsorption of MIL-101(Cr) by Metal-Organic Polyhedral Encapsulation for Adsorption Cooling

Study on heat conduction and adsorption/desorption characteristic of MIL-101/few layer graphene composite

Preparation and direct photothermal property of reduced graphene oxide @copper foam cured MIL-101 for solar adsorption cooling process

Elucidation of Adsorption Cooling Characteristics of Zr-MOFs: Effects of Structure Property and Working Fluids

Fabrication and Thermal Conductivity Improvement of Novel Composite Adsorbents Adding with Nanoparticles

Experimental study on salt–metal organic framework composites for water absorption

High-performance and long-term thermal management material of MIL-101Cr@GO

A Novel Strategy to Enhance the Performance of CO2 Adsorption Separation: Grafting Hyper-cross-linked Polyimide onto Composites of UiO-66-NH2 and GO

Improved Adsorption Desalination Performance of DUT-67 by Incorporating Graphene Oxide (GO)

Performance of MIL-101(Cr)/Water Working Pair Adsorption Refrigeration System Based on a New Type of Adsorbent Filling Method

Highly Improved Microwave Absorbing and Mechanical Properties in Cold Sintered ZnO by Incorporating Graphene Oxide

MOF/graphene Oxide Composite As an Efficient Adsorbent for the Removal of Organic Dyes from Aqueous Solution.

Water Adsorption Dynamics on Metal–Organic Framework MOF-801: Comparative Study of Loose and Glued Grains, and Coatings

Mesoporous Silica‐Guided Synthesis of Metal–Organic Framework with Enhanced Water Adsorption Capacity for Smart Indoor Humidity Regulation

Composite MWCNT/ MIL-101 (Cr)/CaCl2 as High-Capacity Water Adsorbent for Long-Term Thermal Energy Storage

Zr-doped MIL-101(Fe)/Graphene oxide nanocomposites: An efficient and water-stable MOF-based adsorbent for As(V) adsorption in aqueous solution

Doping MIL-101(Cr)@GO in polyamide nanocomposite membranes with improved water flux

Immobilization of Lewis Basic Nitrogen Sites into a Chemically Stable Metal–Organic Framework for Benchmark Water‐Sorption‐Driven Heat Allocations

Improving CO2 adsorption efficiency of an amine-modified MOF-808 through the synthesis of its graphene oxide composites