Abstract:The process of superhard particle breakage in the grinding zone of the fluidized bed opposed jet mill is investigated using the CFD-DEM (computational fluid dynamics-discrete element method) coupling method with the Tavares UFRJ Breakage Model in the present study. The effects of structural and operational parameters, such as target plate structure, nozzle position, air inlet velocity, and feed rate, on the equipment stress distribution, airflow velocity, pressure field, particle velocity, and cumulative particle size distribution are thoroughly studied to determine the optimal structural and operational parameters. Experimental validation is conducted, including scanning electron microscope (SEM) observation of particle morphology and analysis of particle size distribution of ground product particles. The simulation results indicate that the wear rate of the structure without a target plate is lower than that of the structure with a target plate in the grinding central zone. Therefore, the structure without a target plate is chosen for further investigation. The cumulative particle size distribution after grinding is influenced by nozzle position, air inlet velocity, and feed rate. The particle D50 is positively correlated with nozzle spacing and feed rate, while it is negatively correlated with air inlet velocity. The optimal grinding effect is achieved when the distance between the nozzle and the center of the grinding zone ranges from 52.5 mm to 72.55 mm, the air inlet velocity is 950 m/s, and the feed rate is 10.5 g/s. Through experimental investigation, it has been observed that when the feed rate is 10 g/s, the particle size distribution becomes more uniform. Furthermore, consistent trends in the cumulative particle size distribution in the experiment and simulation results can be found, which validates the present numerical model. It was observed that particles at low feed rates retain certain angular edges, while particle roundness increases at high feed rates.

Ejector jet mill with external pressure

A Supersonic Target Jet Mill Based on the Entrainment of Annular Supersonic Flow.

Structural Design and Performance of a Jet-Impinging Type Microbubble Generator

Performance Evaluation of a New Micro Gas Cyclone Using Simulation and Experimental Studies to Capture Indoor Fine Particles

Study on Particle Acceleration Characteristics in Supersonic Jet Field of Fluidized Bed Opposed Jet Mill

The spiral jet mill cut size equation

Fluidized Bed Jet Milling Process Optimized for Mass and Particle Size with a Fuzzy Logic Approach

Micronization of Hard Coal with the Use of a High-Pressure Water Jet

Effect of Nozzle Quantity on the Flow Field Characteristics and Grinding Efficiency in a Steam Jet Mill

Identification of factors to reduce the energy costs of dispersing in jets

The Design of A Degassing Pump Based on Numerical and Experimental Research

Research on the Grinding Process of Superhard Particles in the Fluidized Bed Opposed Jet Mill Based on the CFD-DEM Methodology

Study on the bubble breakup and internal flow characteristics in the pulsed jet ejector

Comminution of Copper Ores with the Use of a High-Pressure Water Jet

Design of low-speed and high-precision scraper feeder for jet mill system

Abrasive Water Jet Milling as An Efficient Manufacturing Method for Superalloy Gas Turbine Components

PRINCIPLES OF SIMULATION OF ENERGY-EFFICIENT GRANULATION PROCESSES IN A FLUIDIZED BED

CFD-DEM Simulations of Graphite Particle Collisions in Opposed Jet Mill

Influence of the Passive Flow Initial Parameters on the Efficiency of Liquid-Vapor Ejectors

A study on liquid film and evaporation characteristics of fuel jet impingement on the scorching wall of evaporation tube for gas turbine

Improvement of process repeatability and resolution in abrasive air jet machining via viscous slurry entrainment