Abstract:Publication date: 30 March 2021 Source: Materials Science Forum Vol. 1025 Author(s): Muhammad Syafiq Mohd Shafei, Zulkifly Jemaat Recent advancement on biological wastewater treatment is via granular sludge technology. It is widely known that, aerobic granular sludge has been developed in a batch operation since its discovery. Yet, most of the wastewater treatment plant (WWTP) is operated in continuous mode. Now, the real challenge is how to adopt the granular technology while maintaining present operation mode of WWTP. Thus, this study attempts to evaluate the feasibility of developing aerobic granular sludge in continuous airlift reactors feed with two different substrates, namely glucose and acetate. Two identical airlift reactors (6 L) were employed and operated at room temperature (30°C). Prior to the substrate feeding, both reactors were inoculated with seed sludge obtained from a palm oil mill anaerobic pond. One of the reactors was fed with 2000 mg COD L-1 of glucose (ALR1) and the other reactor with 2000 mg COD L-1 of acetate (ALR2). The hydraulic retention time (HRT) and organic loading rate (OLR) for both reactors were maintained at 4 days and between 0.2 to 0.5 kg m-3day-1 respectively. Dissolved oxygen was maintained between 5.0 and 6.0 mg O2L-1 and supplied by air compressor. The reactor performance was monitored based on COD removal. Aerobic granules developed throughout the study period was evaluated based on granules size and morphology, sludge volumetric index (SVI30) and SVI5/SVI30 ratio analysis. Results showed that ALR1 demonstrated the formation of filamentous-type aerobic granules with most of the SVI30 average at 100 to 190 mL g-1. Ratio SVI5/SVI30 analysis was evaluated at 0.2 and 0.5. The largest granules size obtained during the experiment was about 600 μm on day-136 and average granules size obtained at 200 to 400 μm. ALR1 able to achieve 95% COD removal. For ALR2, round shaped aerobic granules were developed with average SVI30 from 100 to 1000 mLg-1. SVI5/SVI30 analysis indicated an average ratio between 0.7 and 0.9. The average granules size was between 30 to 50 μm and the largest was 78 μm on day-60. 90% of COD removal efficiency was obtained in ALR2. In conclusion, ALR fed with acetate had indicated better aerobic granules characteristics as compared to glucose fed reactor. Furthermore, the study demonstrated that to develop aerobic granules in continuous reactors is feasible.

Aerobic granules cultivated using industrial rubber wastewater: Effect of size distribution and Performance of granules.

A Case for Aerobic Sludge Granulation: from Pilot to Full Scale

Rapid Aerobic Granulation in an Sbr Treating Piggery Wastewater by Seeding Sludge from A Municipal Wwtp

Formation of Aerobic Granular in Pilot-scale SBR for Real Wastewater Treatment

Formation and Characteristics of Aerobic Granular Sludge for Simultaneous Phosphorus and Nitrogen Removal in a SBR

Aerobic Sludge Granulation in a Full-Scale Sequencing Batch Reactor

Cultivation of aerobic granules in a novel configuration of sequencing batch airlift reactor

Effective removal of organic substances and nutrients using microgranular sludge in a sequential batch reactor

Effect of COD/N ratio on cultivation of aerobic granular sludge in a pilot-scale sequencing batch reactor

Granulation of Completely Autotrophic Nitrifying Sludge in Sequencing Batch Reactor

Anaerobic/Oxic/Anoxic Mode Sequencing Batch Reactor: Treatment Performance and Development of Aerobic Granular Sludge

Granulation of Activated Sludge in A Pilot-Scale Sequencing Batch Reactor for the Treatment of Low-Strength Municipal Wastewater

Performance of Aerobic Granular Sludge for Domestic Wastewater Treatment

[Cultivation of aerobic granules in a large pilot SBR with domestic sewage]

An Attempt to Develop Aerobic Granular Sludge in Continuous Airlift Reactors

To Optimize Sequencing Batch Reactor (SBR) and Monitor Aerobic Granular Sludge (AGS) Development for Domestic Wastewater Treatment

Aerobic granulation in sequential sludge blanket reactor

Sludge granulation and performance of a low superficial gas velocity sequencing batch reactor (SBR) in the treatment of prepared sanitary wastewater.

Characteristics of aerobic granule and nitrogen and phosphorus removal in a SBR

Aerobic Granulation Strategy for Bioaugmentation of a Sequencing Batch Reactor (SBR) Treating High Strength Pyridine Wastewater.

Cultivation and Characteristics of Aerobic Granular Sludge in Sequencing Batch Reactor